HONDA G DASH
It was based on the DJ-1RR, a motor scooter that travelled in an active manner. It improved its intake, exhaust, and combustion efficiency to raise its torque at mid speed range. It was a highly maneuverable motorcycle.
I intended to replace it from an OEM bulb, but as I tried to replace it was the same form of Small thread
Halogen bulb was equipped. (Because I had never been replaced by a used car)
It may be affecting that the current Lamp ball was blacked a bit,
It got much brighter. Speed ??of the original is nearly satisfying brightness.
Not only the irradiation destination, but also the hand is bright feeling.
The light source is also very natural color and safe.
The price is about 3 times as much as the OEM ball, but I think that it is worth the price.
I used a Halogen sphere of MICHIBA, a Manufacturer who I do not know well, but since the low ball has run out, I replaced it for this product. When exchanging from NORMAL sphere to MICHIBA, it rarely felt the difference, but this product is good enough to think that Lens cut changed. First, the irradiation range of row is Quantity : Pair (for Left and Right) It gets wider, and the high lights far in the form of Spot. I am surprised to see whether the same Halogen is different up to here ....
However, because of high efficiency, life is a little worried.
I used 12v 30w thing attached to masters.
Certainly Home centeretc. Compared with the sola sold in. (It will not brighten dramatically)
However, whether the solder used for the contact part with the electrode of Valve is not very good, or if it ran about 4000 km, the solder melted with heat and broke.
It may be a fate of high efficiency Valve, but it is too bad that the price is expensive.
Dual head of CBR 150R is dark. 18WX2 So there are some sides that can not be helped, but it is too dark as a motorcycle that can run on highways. So I tried putting the classic pine Stripe. It got pretty bright and I became able to run freely without anxiety.
Although it is dark compared to HID and LED which became the mainstream of four wheel vehicle, CBR 150R is AC power supply (FlywheelMagnet) Therefore, when it is tried to change to the HID and LED of the DC power supply, it has to be replaced from the power supply itself, and even if it is difficult to make it by hardship, the focus often does not suit well, "Too much labor and no success" Sometimes it becomes. Light of AC power supply is easy and reliable to replace with pines Stripe.
There are also people who want to make the number of Watt Large by thinking to make it bright, but it is meaningless rather than to Flywheel Magnet car with a limited amount of electricity generation, rather it gets dark, so it is good to keep Watt number as Standard.
When attaching Valve of PH 7 type, as to keep the convex part of the Gold tool properly in the concave part of Light. If you do not do this, the focus will come to strange places.
The disadvantage of the pine Stripe Motorcycle beam is that there is somewhat difficulty in product accuracy. I purchased it many times, but there were times when the position of the Filament was misaligned, and Glass itself was distorted. When buying at the shop front, it is good to check whether there is any distortion. In the case of mail order, when it arrives, let's check firmly before opening to see if the accuracy is accurate.