Reviews
Easy to Ime Chain
I want to brighten up the Tire section a bit,
To match Body's Red.
MDF Mirror red 6mm is attached.
I forgot to buy the Sticking Gauge for Rim Stripe, so I'll put it on by feel.
Well, I was able to do it just fine.
View detail
It stands out on Gentle because it reflects beautifully depending on the angle of view.
I applied 16~for 17in. of MirrorTYPE Blue to a 10inch Scooter. I am satisfied with the feeling that the Wheel itself became more luxurious than the original color! View detail
Mirror gold
I purchased 6mm Mirror gold. I applied it without Gauge. I cleaned the applied area, degreased it carefully with Silicon-off, sprayed it with water containing dishwashing detergent, and finished it with Dryer. It has been summer and winter since I applied it, and so far there is no sign of it peeling off. View detail
The thinning liquid is a Large thing if the procedure is followed.
I tried my first ZDress-up.
After much research and hesitation, we decided on Mirror violet, with the theme of casually shining and glowing.
The first step is to install the wheel, using MDF Scale, which I have used before, and first degrease the wheel thoroughly with Silicon-off.
After the entire wheel is removed, the adhesive is simply applied using Scale while spraying a detergent thinning solution.
I followed the procedure to paste one of the 4 stripes, but it suddenly peeled off, failed, and fell to the ground, unusable! I try to paste one more piece, but it feels slippery?
The cause was that when making the diluent, the amount of neutral detergent was wrong and there was too much detergent, so the adhesive was not strong enough and it fell like a stream...
After adjusting the thinning liquid again, the adhesive strength improved and work proceeded smoothly, but there was no room for error, so we proceeded with caution and care.
After that, I managed to complete the job on all four wheels in one shot, and upon confirmation, a drop or two of detergent in the thinning solution should be enough!
Small diameter wheels have a large bend, so even if you use a dedicated scale, you need to be careful.
The impression of the finished product is quite good, with a very austere appearance.
When the sun is low in the morning and evening and light reaches from the side, Mirror's flamboyance is emphasized. On the other hand, when it is cloudy or at night, it gives the impression of a dull reflection and glow.
The Violet is a darker color, so it is not so noticeable in the absence of light.
I have been using MDF's Stripe for a while now and the durability is excellent, the thickness and quality are definitely better than cheaper ones, but a word to MDF, can you please make the Small Diameter WheelSpec. in a little more quantity instead of just two spare sheets?
Large and Small diameter Wheels with bends require a lot of construction work and hang.
Even with the use of a dedicated Scale, the work was not as nerve-wracking as it could have been.
View detail
Casually add Accent to Wheel
Since the wheel color was originally Bronze, the area around the tires and wheels looked rather plain. We also had a hard time choosing a color for the rim stripe that would go well with the Bronze color. As a result, we applied Mirror Bracket's exclusive type of Silver, and it became an image like the shine of cutting rather than the accent of the color, accent of the genus Gold or Plating. It is not flashy, but I like it because it adds accent like a large person.
Paste is a dedicated Gauge, Squeegee, and soapy water (Mist spray) Anyone can apply it beautifully if they have it.
View detail
GoldMirror Bracket Exclusive Type (6M) Installation
I used to have these on my V-strom and was satisfied with the quality, so I chose the MDF ones without hesitation.
I thought it would stand out with GoldMirror Bracket exclusive Type, but it's not so flashy and it matches well.
In the beginning, I used a special attaching gauge, but is it not suitable for the Small diameter wheel? It was difficult to adjust the position, so I applied it without using the gauge. There is a place where the matching surface is a little off, but it is not a problem for me because it is not understood unless I look closely.
The effect is Large for a little dress-up.
View detail
A little pricey for what it is.
The quality is Level with no problem.
If you paste it according to the Instruction Manual, you will not have too much or not enough Tape.
I was able to attach it without any problems.
I think it is better to use Maintenance Stand for Rear to put it nicely.
View detail
One point Accent on Wheel
Because the wheel of MT-07 was all blue and felt too much assertiveness, Mirror is chosen to reduce the blue color & hellip;
The balance of the balance of the width is also good, so I am satisfied with Large.
View detail
good visibility
It's Mirror Rim Stripe, so on a clear day when it is reflected in sunlight, it sparkles and is easily visible. It has good visibility and has a reflector-like effect, so it seems to be helpful for safety. I bought it for 6M, and I will buy it for 10M next time. Because it is a Mirror Rim Stripe, when it is reflected in sunlight on such a clear day, it is bright and visible. It has good visibility and has an effect like a reflector, so it seems to help with safety. I bought it at 6M, but next time I am going to buy it at 10M. translated by google translate View detail
Design is nice, but …
Quantity:1 Set is all Quantity:It was a 1pc. seat, and it seemed very difficult to do, so we divided it into 16 parts per pc I did
I think this was a Large correct answer
It's easy to work with the Divided and Applied Gauge
The design is perfect, but the overlap is a bit annoying I'm also wondering if each one is expensive
View detail
It makes quite an impression
It has been installed on the BlackRim of XG250 TRICKER I appreciate it
I chose the Mirror red, when I first got it, it looked a bit plain and I thought it was a mistake I thought I'd like it, but when I actually put it up, it's quite an austere impression
Also, because it is a mirror, it shines depending on the angle from which it is viewed, so there are two different impressions, one austere and the other a bit flamboyant This was a good choice that I never got tired of, as there were
And it's quite conspicuous because it doesn't seem to be around much and attracts the attention of others, my car Makeover and the best self-satisfaction I've ever had
We used the special gauge to apply it The result will be the same as the original
In addition, I think it's good to prepare for installation while crimping with Dryer because it's recommended
I stuck it as it is after Rim degreasing with Silicon-off, but it is still two years old It will not come off
View detail
It's a bit expensive
Because the body line is gold, I thought that gold color would be more suitable than silver stripe I bought it because I thought
It looks beautiful in the image, but it is a special type for Mirror Bracket, so you can use it as an image is the same as the Gold color of Origami (the one the kids have)
Call it fancy, but when I say fancy, I mean plain, I mean subtle (laughs)
Instead of Gold, I think it should be Blue or Red or some other color
This is the only one that suits my Machine as it only looks good in Gold, so this is the only way to rate it
View detail
Pretty much Beauty
If you follow the instructions, it's not that difficult to paste
Dryer after pasting is very important. 10mm size is also good
View detail
Four stars
I have not attached yet, but I feel I saw it, things looked good so I am satisfied. Gloss and texture are good, and it seems that it is hard to peel off, so I am looking forward to attaching it to my motorcycle. Since I bought the installation tool together at the time of purchase, I am expecting to be able to stick beautifully. View detail
Mirror Bracket Special Type
I pasted it on Blue's Wheel of L7GSX-R. Mirror Bracket exclusive type Why it reflects and it feels like Pink? Purple?. I see Red color when I see it nearby (Lol)
But it became Accent and it became a good feeling! (^ ^) I like it..
View detail
Mirror Bracket Special Type
I pasted it on BlueWheel of L7GSX-R. Mirror Why is it reflected and it looks like Pink? Purple?
I see Red color when I see it nearby (Lol)
But I felt good with Accent. I am satisfied! (^ ^)
View detail
Gold Wheel to GoldPlating Rim tape
Honda's GoldWheel is a little tasty so add Rim tape as Accent.
Infinite Spec. Think of the colors of RedRim and Others as you would like to add color to Paint in the car image
Purchase a Plating dare to compare GoldWheel and try to buy a little expensive.
Unlike ordinary White and Red like Type, Plating type has a thin Tape.
Since the back is Silver's Tape, the adhesion is also weak. Even if it is degreased and pasted it will be stuck again
I worry a bit about I can do it. Inversely speaking it was easy to paste. Without Guide.
But durability is A little worry. I expect it in the future
But well Major Parenthesis I wonder if I am getting better!
View detail
It is good ♪
I have also used it for the past Motorcycle, but it is good ♪
Mirror seems to be flashy, or it may be better than Solid Collar without being too conspicuous unexpectedly.
I also have two spares and the Instruction Manual is polite and good ♪
View detail
It is expensive for inexpensive goods, but it is commensurate with it
While bad inexpensive goods are on the market, I chose this because it is a reliable Brand.
Even in the pasting stage, you can stick it cleanly and have no complaints.
No complaints with a beautiful appearance after pasting.
About 1 year passed after pasting but there was no deterioration such as peeling.
Large This item is satisfactory.
It is also a very good point to be able to fine-tune Order.
View detail
Satisfied with CostPuff performance
Purchase wants to change the image of silver wheel. I made gold of my favorite color.
Size is 4M - 6M - There were 3 types of 10M and I got lost, but I actually cut and pasted a vinyl tape on the wheel of Motorcycle to confirm the mounted image, and chose the result 6M.
The delivered product has a texture higher than I thought, and a manufacturer's sticker is also attached and I am satisfied.
Since it is the first paste, I also purchased the Sticking Gauge for Rim Stripe. If you have little pasting experience, we recommend you to purchase at the same time.
In addition, the product of Bae Wei is cheap in price, packing - Shipping is also polite, I will always buy with confidence. Appreciation.
View detail