Reviews
This is an exclusive product for Active's Holder.
Introduced on MainMotorcycle's XJR1300C High Solo.
Throttle holder uses Active's Type-3.
The size is 44Φ, although the NORMAL is 37Φ, which is very lax,
44Φ to be about 63°, so it is a bin bin Spec.
If I feel tired from using it, I will 42Φ.
View detail
It is a solid making
It's not too rough to make.
Good.
View detail
I almost never think of anything else.
Custom vehicles around Throttle are almost always by Active.
This time, I chose a small caliber for use in TMR. I think I have probably already selected almost all the sizes.
If used for TMR, a SEA BASSOEM variable-ratio Throttle pipe could have been used.
View detail
To change High Solo setting
Purchased to change High Solo settings.
The beauty of Active is that you can set this detail.
Thank you.
View detail
It's an ordinary throttle pipe.
I purchased this product because I heard that it is a large machine that can be diverted to the OEM holder of WR250X. In conclusion, you have to modify it to install it. I don't have anything bad to say, just use the R6.
I processed it, but it was subtle, so I took it off. The thing itself is an ordinary inner.
View detail
Processing and mounting
I bought 40 π at GSX 1300 R HAYABUSA cheaply, but I purchased 40 π at GSX 1300 R HAYABUSA, but because it was too large at NORMAL, I tried to scrape the surroundings with thunder, I could set the installation to Smooth but it became a little like High Solo It was Kana, I will Recommendation to purchase after confirming Size well. View detail
Although it had not equipped with a high-throttle kit,I managed to equip the original product with one.However, I must admit that it is not just easy for anyone to do it.Since you could have an unexpected trouble depending on how to finish, it
Although it had not equipped with a high-throttle kit,
I managed to equip the original product with one.
However, I must admit that it is not just easy for anyone to do it.
Since you could have an unexpected trouble depending on how to finish, it needs self-responsibility.
Shaping takes for about 1 hour, and installation for 1 hour.
It is ok to adjust the wire up to the limit of adjuster.
Although 40mm was chosen, by a handful grip, it opens fully and accelerates. The grip tiredness at the time of cruising decreased.
Since speed becomes faster than before at the time of acceleration, it is also good.
Although it may take sometime to get used to its ride, it's only a matter of time.
I will recommend this for those people with the knowledge of DIY and motorbike maintenance.
View detail