【ACTIVE】Teflon Inner Pipe Review

ACTIVE teflon inner throttle pipe/grip in use with ACTIVE aluminium throttle holder

I installed this teflon inner pipe together with the ACTIVE aluminium throttle holder with the 2 fast throttle cables to operate the Yoshimura TMR-MJN40 racing carburetor. the size that i have chosen is the 40mm (which is the maximum for the ACTIVE throttle holder Type-2). It is a straight forward and easy installation, and after sucessful installation, the grip, the throttle response and operation of the TMR-MJN carburetor is much better and livelier. highly recommended upgrade even it is for normal carburetors. View detail

This is an exclusive product for Active's Holder.

Introduced on MainMotorcycle's XJR1300C High Solo.
Throttle holder uses Active's Type-3.
The size is 44Φ, although the NORMAL is 37Φ, which is very lax,
44Φ to be about 63°, so it is a bin bin Spec.

If I feel tired from using it, I will 42Φ. View detail

When the Grip heater is installed

The SEA BASS OEM Throttle is engraved with a Giza Giza and Rib to prevent the Grip from shifting.

I'm too lazy to shave off the Rib, so this Teflon (R) Use the Inner Pipe to attach the Grip heater.

It's a little pricey, but it's convenient because you can choose the diameter of the windings, so you can make it Large, which is close to OEM, or you can make it a little High Solo.
View detail

The diameter of the inner pipe can be changed.

This time I needed it for radiphone purposes, not for High Solo. I chose the Φ40, which is almost the same as the NORMAL, with the same throttle response.
If you don't like the accelerator operation at low speeds to become severe and difficult to ride, this is Recommendation. View detail

Used to change the winding diameter

I used it to change the winding diameter of Active's High Solo.
I wanted to make my Solo more High Solo than the diameter that came with it, so I bought the Large diameter ones.

I'm not a big fan of the High Solo, but it's not as easy as it should be. View detail