Reviews
It cannot be pontooned. But Rim width is Quantity:Pair (for Left and Right) I like the fact that it's all even, etc.
I purchased Front 3.5J and Rear 4J. Please be careful. Personally, I think that the depth of the rim is more than enough.:Pair (for Left and Right) I bought it knowingly because I didn't want it to be a "one-size-fits-all" type of arm. If you want to mount it on your car, you should use KITACO or GKURA's Quantity.:It is better to buy a Set product. View detail
Think carefully before buying.
First, this Wheel has Offset 0.
Therefore, it cannot be pontooned.
I have installed it on OEMFront fork + OEM hub,
If the gear is left as it is, it will be close to the meter gear side and will hit the boots of the fork.
I opened the package and looked at it, and then I did it...…no offset...…….
What's wrong with Offset 0?
I can't help it when I want to DISC.
If I buy a Disk hub kit from the same manufacturer, will it be attached as is?
I don't think it will be easy to pop it in, since it is only a Chinese component.
I would like to see a statement such as, "Processing is required due to no offset.
Manufacturer is also a Manufacturer.
(Added:We were stumped when we inquired about it.)
Rear will change as well.
Recommendation to attach SprocketOff-set Spacer2mm in color and Rear.
Since no offset
If you don't put it in, the Chain line will not be aligned.
3.OEM hub and Tire despite 5J (110/80-8)
So Spacer is a must.
Since GCraft's Wheel is Offset.
You can pimp it
As a result, it can be installed by processing. However, it is not possible to
When you want to make a different Wheel/disc, you will have to buy a hub or put in a color. Why?
This is because the hubs need to be packed and cannot be put back together.
I'm sure a hub from the same manufacturer would fit.
No matter how far you go, Chinese is still Chinese parts.
Are you aware of the processing before you buy?
If you want to use a pontoon, use GCraft's or KITACO's Wheel.
View detail
FrontWide
I had a 4j in my car, but I bought it to make it wider.
I think it is well made. I haven't tried it out yet, so I don't know if it's shaky or not.
View detail
Buy for front and back
I bought two 4j's for front and back, but I thought the luster of the surface was uneven on the product, but I polished it well and it came out the same as the front and back. View detail
I think that accuracy is high
First we took out of the box and there was a dent in the Stabilizer section due to its appearance. It is good because it is a hard to see part - - -.
There is no problem with regard to installation.
View detail
Required for Aluminum Swingarm for GM-MOTO APE
OEM's Axle Shaft seems to be too long to divert, so I bought it with Swingarm.
Since shipping costs will apply when you purchase it separately, please be careful not to forget to buy when purchasing Swingarm.
View detail
Watch Impre
Impre looking,
I bought it as a reference for the time being.
Although I bought it and installed it
I do not know if it's good or bad.
Later, I just pray that I will not break.
View detail
Often or bad, it is not (^^) Ordinary epsilon - ('∀`;)
Often or bad, it is not (^^)
Ordinary epsilon - ('∀`;)
View detail