【NTB】Brake Switch Review
Fits: HONDA HornetCB900F (Hornet), HONDA Hornet900 (Hornet), HONDA CL400, HONDA CBR929RR, HONDA CBR600FX, HONDA CBR600FS, HONDA CBR600FR, HONDA CBR600F4i, HONDA CBR600F, HONDA CBR1100XX, HONDA CB400 SUPER FOUR (Super FOUR license training vehicle), HONDA CB400 SUPER FOUR (Super FOUR), HONDA XRV750, YAMAHA XJR1300, YAMAHA XJR400RII, HONDA CB1300 SUPER FOUR <ABS>., HONDA CB1300 SUPER FOUR <ABS> (SUPER FOUR), HONDA XLR125R, HONDA XL1000V, HONDA XLR200R,
Almost satisfied
CBR600RR (PC 37 latter term 2005 year) It attached to. I swapped it for 12 years because it became useless.
I thought that the product was the same as it was originally attached. (Maybe you just did not notice the difference)
Behavior also works without problems so it was good.
Responses
Other reviews
NTB FrontStop-lamp switch for HondaDREAM50.
I have always found NTB products to be inexpensive and of high quality, so I ordered from them again,
The signs speak for themselves." This is what I mean,
I realized that NTB's products are nothing less than OEM parts,
View detail
Purchased as Repair Parts Stock
I bought it as Repair Parts stock. stop switch is suddenly ruined, so I stock it. View detail
It's okay, I think.
Has the stop-lamp light been unstable lately? I checked to see what it was, and I suspect it's the Switch or Wiring area of the front brake.
It seems that there is no problem in the energization of the wiring, is it made by OEM Alps Electric? I ordered it to see how it works because the Switch of
The next day it arrived, I was surprised, when I replaced it, the problem was solved at once.
The difference between the OEMSpec. and the OEMSpec. is that the parts around the terminals and near the terminals do not seem to be waterproofed.
If it is used as it is and there is a problem, it will be disassembled, and the contact point and the energizing part will be cleaned, and I think that Maintenance will be done.
When energizing and investigating this time, when lighting is unstable, first of all, it may be the best to suspect Switch, when it is Single Body without installing Switch, it lights without a problem, but when I operate it after it is installed and fixed, it does not light, it blinked and became unstable.
Later, I disassembled the OEM, but it seems to be a distortion of the contact point or inaccuracy, and it depends on a slight angle of Lever to energize or contact failure.
The original installed OEMSwitch is not reusable for safety reasons.
I have experience with malfunction from dirt and degradation carbonization of contacts, but it is the first time that contact failure occurs from a slight distortion of Case or current-carrying parts.
It often revives when I polish the contact points and the energized parts and put them back together again, but it is a part that needs to be operated reliably.
View detail
Not good
It stopped working about a month after the replacement.
Phenomenon:Stop-lamp is still on even if you don't hold Lever.
It seems to have developed a sticking inside. Lubrication did not improve it.
Well, I've been storing it outdoors with a Cover, and I've been hit by rain a few times …
View detail
Ordinary Switch
It was broken before I knew it, so I replaced it. Normal Switch with nothing of note at all, thank goodness it's inexpensive, nothing to write 60 words on. Normal. View detail