【AirTec】Air Filter Review
Fits: HONDA CRF250R, HONDA CRF450R, HONDA CRF250X, HONDA CRF450X
usually
It's normal. It's so ordinary that it's too ordinary to comment on. The price is also normal. But what is normal is that it is Large. The super cheap ones from overseas are so thin and coarse that you can see at a glance, so you have to discard them immediately after purchase. It is said that CRF will reduce intake air Valve, but the air cleaner I don't think that's true if you manage it. The entire JapanTeam is aware of this, as is the fact that Racer is an Air cleaner management Large It is.
Responses
Other reviews
Product Introduction Page may differ slightly from the one on the page. (It is supposed to be improved.)
The product arrived and I used it.
I think it is the same etc. as OEM in terms of feel.
I did not notice any difference in performance.
I think it is a good product because it is reasonably priced.
View detail
Replace the old one
This Manufacturer is a Repeat buy, it's cheaper than OEM Product and the performance is about the same! View detail
I only use cheap ones.
I used to clean it with kerosene and Gasoline. (Filter cleaner all the way this time) I can't compare the frequency of use, but it seems more durable than the Other Brand Product I used before. I can't tell the difference in effectiveness. It is a consumable item, so I will wash it often and when it gets old, I will buy a cheaper one again. View detail
This is a cheap one.
I used to use it when I was on Air BoxSpec.
This is a good and cheap product.
Setting is also determined, and Power comes out more than Normal.
good point
Cheapness and performance.
Carburetor setting is easy to produce, a little darker than NORMAL, Large and strong.
Easy to clean. Can be washed with neutral detergent.
A bad point
None
I think the expensive ones are good, but if you're looking for something cheap and good, I'd recommend this one. ,.
View detail
Shame about the shape change.
The previous MODEL had a hole for the Bolt that could be co-tightened with the Air cleaner lid.
The one I received this time seems to have lost it and has the same shape as the OEM.
If it is possible to co-tighten with the bolt, there is a sense of security that there is no gap even if you remove the protective gold netting that is attached under the air cleaner, and the Power Fee Ring was a little better...but it is a pity.
I think I'll try gluing the Bolt holes together with EVASeat or something, but it's a pain.
The price is almost the same, so next time I'll go with another company's Bolt hole.
View detail