【DAYTONA】Special Air Breeder Review
Fits: HONDA LEAD 50, HONDA MAGNA(V-TWIN MAGNA), HONDA MAGNA(V-TWIN MAGNA), HONDA MAGNA(V-TWIN MAGNA), HONDA LEAD 50, HONDA LEAD 50, HONDA NS50F, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgman Type S,
If you want to buy an OEM, buy this one.
I bought this as a replacement from OEM
very high (Lol) Expensive for nothing. (Lol)
The color of 64Titanium material of the same size is SilverTitanium and about 1000 yen.
Quantity Stainless this time:2pc. I bought a set.
I also bought the 64Titanium and am waiting for it to arrive!
I may return this one depending on the decidedly texture!
Responses
Other reviews
Purchased wrong size
I bought the wrong size. I'm thinking of buying it again. View detail
Replaced because it was rusted.
I bought this Motorcycle used, so I replaced it with a Caliper while I was doing CaliperOH.
I bought this one because the existing one had some rust.
View detail
Corrosion protection only
I've been sticking with the Tokico 6 pods. This time I adopted CaliperOverhaul and baked paint instead of OEM. I think it's a good corrosion protection. I've heard that some people use seal tape to prevent leaks, but I don't use seal tape because I have to loosen the Breeder repeatedly to keep the air out. I've had OEM jams in the past, but I'm not sure if it's because of the stainless steel. I'll have to wait and see. View detail
It's safer to change it.
The OEM Bleeder Bolt is always going to Rust and Decay, so this Material:It is safer to replace it with Stainless Steel.
Be sure to bleed the air and refill the fluid in the MASTER after replacement.
The Bleeder Cap was made by Straight.
View detail
I put it on my ZrX1200 DAEG.
ZrX1200 DAEG OEMHydraulic Clutch Bleeder Bolt This Material:I replaced it with a Stainless Steel one. The OEM Bleeder Bolt is made of steel and will always rust over time, so it's best to replace it. Don't forget to bleed the air and refill the fluid in the MASTER after replacement. View detail