【PRO TAPER】EVO Handlebar Review

MODEL Woods HIGH

Used on YZ250FX
Height 180cm
I use it in StandingMain in Course, and I feel that the width, height, and pull of the handlebar are all good for me, and it seems to manage the vibration of the engine very well.
It has been rolled quite a bit, including the lock, but it is only slightly bent and has good durability. View detail

I thought it was a basic Handlebar.

OEMHandlebar of ktm250tpi is Quantity:Pair (for Left and Right) 1.It was replaced because it was 5cmCut and Handlebar was shaken.
On the difficult course, I could go with a short handlebar, but on the normal MX.EDCourse, when I raised the speed, the handlebar with cut was out of control and I was tired of holding it back.
When I replaced it, the handlebar width was wider and it was easier to control the front swing while driving, making it a little easier to drive.
There is a slight difference in height and pull from the ktmOEMHandlebar, but not much, and after one day of running, I felt no discomfort. View detail

Handlebar height and strength increased

OEMHandlebar was bent during a fall on a forest road, so it was changed.
The handlebar is thicker, so I also purchased a universal mount kit, which raises the height of the handlebar and makes it easier to stand.
crf250l md47 because it interferes with banjo bolt
The Clamp of the Hand Guard is changed to a Long Type UClamp, and since the length of the Hose from the Master Cylinder is not long enough, it is necessary to remove the Hose from the S-shaped Hook that is guiding the Hose. Also, if you put a Bar pad that fits this, it will be a little troublesome to insert and remove the key. However, considering the strength in terms of performance and ease of standing....
I haven't tipped over since I replaced the handlebar, so I don't know how strong it is. View detail

More rigid, lighter!

It's more rigid and stable!
That's what I call a Pro taper! View detail

There is an error in the numerical table.

I thought I had purchased the Large size of the pull, pondering while looking at the numerical table of the product Page.
In fact, the C (pull) part was the rise and the E (sweep) was the pull.
The other diagrams in the productPage helped me to understand it correctly.
I was only looking at the numerical table and overlooked it.
I'm honestly bewildered, but it's not a bad product so I'll keep using it.

It would be great if webikeStaff could review this Review and correct any errors. View detail