【SSK】Aluminum Drink Holder Review

Screw goes missing.

It is used with Pillion Bar.

Quality as a Holder is perfect!
It is well made and highly satisfactory.

However, the screws for adjusting the Large size may be prone to falling off.
If you don't squeeze it properly and drive with it loose, it will fall off before you know it.
Once it is lost, it is even more likely to fall off with other nut, etc. Therefore, it may be necessary to first apply Screw lock to the tip of the Bolt to prevent it from falling off. View detail

Drink holder

I am very satisfied with the way it is made.
It is very good because it can be easily adjusted according to the Drink Size. View detail

Speedra Drink holder

Installation was easy and I was satisfied with both the design and the quality. View detail

Mounted on PCX160

I installed it on my PCX160.
I bought this because I was missing One Side with the Handlebar Brace installed and the Smartphone Holder.
The texture is pearl and I like the simple design.
You can adjust the width of the bottle with the knob on the bottom side, so you can make it fit your plastic bottle just right.
I recommend it because it is very reasonably priced. View detail

It's not bad!

No problems and useful.
If I had to make a complaint, it's a matter of personal preference, but the paint job is a bit cheap.
It's a shame that the pictures of the product didn't show it clearly.
I would have given it a 5 if it had a texture like the Aluminum Cut-Out. View detail