Reviews
Windproof performance is high, but WaterproofRib is tight
Mounted on SEROW250 over ZETA's ArmourGuard.
Although a slight draft enters, the windproof performance is high because it fits completely up to the wrists.
Although the opening is Large, the waterproof rib is Small, and it is in the way when inserting/removing hands or operating the blinker.
View detail
In the cold season.
Mounted on GSAdventure
Cold Season
Even the thin leather Gloves are good for keeping my hands cool!
It will be slightly difficult to operate switches.
Once you get used to it, it won't be a problem.
View detail
Very effective and good
It's the best Cover I've ever used, easy to get in and out of the hand, although it would be great if the fingertips were improved. View detail
It keeps out the cold.
It will keep your hands much colder in the winter.
I highly recommend it.
View detail
A little hard
It is easy to install. and good, but I would like to improve the area around the Brake lever, it feels like my fingertips are jammed, it is comfortable and works well with the Grip heater. View detail
I can operate Switch directly…
I'm a little concerned about the wind blowing in from both SIDE… View detail
Recommendation for TRAIL vehicles
It can be installed over the Handlebar Guard of TRAIL vehicles, and because of this, the Cover is not affected by wind pressure and has a spacious interior, so we recommend that you hardly feel any discomfort in lever operation. View detail
Knuckle guard on top
Handlebar cover that can be installed over the knuckle guard
It is easier to be a little aggressive when installing.
DL1000 V-STROM250 and DL1000 V-STROM1050XT installed without problems
But the most important thing is that the handling in driving is the worst.
Button operation is almost impossible.
should be used sparingly
View detail
Waterproof effect exceeded my expectations.
I used it every day for one season while commuting and touring, and it is durable enough to last for the next season.
The windproof and coldproof effect is just as you say, and this alone is indeed not enough to survive midwinter.
Use a hand warmer or a Grip heater as it gets tighter after hours of riding.
There was a time when I left my bicycle in the company's parking lot out of the rain, and the waterproof effect is quite good.
Note that the Accessory Case portion is not waterproof.
While it was easy to install, it lacked stability and I was concerned about wobble.
Also, I have a sensation that the wind is holding my hand down from about 80?
If a hand guard is attached, I think the above two can be improved at the same time.
I'm glad I bought it because it didn't look as bad as I thought it would look on my V-Strom 650.
I will use it again next Season!
View detail
Hand warmer
It was warm and very useful. View detail
Thank you for your help.
I use a motorcycle for commuting. I used to wear a thin pair of Breath Thermo gloves inside my winter gloves, but since I use 12km of highway in a 30km distance, it was getting to me! 。 I was concerned about the stylishness of the product, so I thought I would at least get the Knuckle guardDemonstration, but I bought this product for practical use. 。 I can control the blinker and other functions inside. I think it would be more comfortable if I added a HandlebarWarmer to the car, but since it is an old car, I haven't thought about the load on the battery. 。 I really hope that some manufacturer will develop a warmer that can be supplied via USB. Anyway, thank you for your help. View detail
Adventure will look good.
[How is it used?
1 hour commute on the highway. A little touring.
Was the one you received as per Image?
Yes, as per Image.
How was your experience with it?
until now You look like an old man. I had never used it before because I thought it was too expensive, but now that I'm really an old man, I gave it a try. I regretted why I didn't use it earlier. There are many mistakes in life.
Even in the middle of winter (about 5 degrees Celsius), you can go fast for an hour without a grip heater, and even summer gloves are large and sturdy. This is amazing.
It's like a lie that I used to be so cold and rattled with pain in my fingers even when I used to wear tough winter gloves (which I don't like much because of their poor operability). Young people, let's be old men.
Strangely enough, V-strom has You smell like an old man. I can't see it, maybe Off cars in general have an affinity for it. I'm sure the SS will be uncomfortable, though.
[Points to note]
The V-Strom has a hand guard, so it's not a problem, but the wind pressure may push the lever.
Also, because of the hand guard mentioned above, I tend to be a little forward and can only get my hands in shallow.
It is a bit of a hindrance when operating the Blinker. You have to use a little force to operate it.
I would give it a Minus star.
This is not a problem specific to this product, but please be careful when you are not used to it.
View detail
It's not insanely good, but it's not bad either.
I was able to install the Handlebar of C400GT without any problem.
The operation of the Button is not a problem, but it is necessary to remember the position firmly because Button is hidden naturally.
good point
*It is covered firmly and operation is almost no problem.
It does not interfere with the buttons.
The only thing that is hard to push is the Right Side heaterGrip heaterButton, but it's not used while driving on the Right Side, so it's not a problem.
*Not bad to look at.
Unlike Type, which is like Boxing Gloves, it doesn't show too much of life.
*The price is right.
I was confused with Goldwin, but I decided to go with this one because of the double difference in price.
I thought it was a good price.
What's not so great about it
*The Material is windproof but not very warm, so you don't feel like you're being kept very warm.
*The front of the car is fine, but the wind rolls in or my wrist gets cold.
If you think it's a little cool inside, this may be the cool factor as the wind comes in through the drainage holes. There are two holes inside and one at the entrance. (3rd photo)
I think it is better to block it with Tape etc. in winter because there is no use other than water intrusion in a rainy day.
*Gathers for Waterproof are in the way of getting your hands in and out.
It claims to be large and sturdy for rainy days, but I don't ride in rainy days that bother me that much to begin with, and I don't need holes for drainage.
Why don't you just release that part separately in a rain-compatible MODEL since it's in the way? I thought.
I think I can CostCut it with just Gathers and no holes.
View detail
Winter handlebar cover
The model I chose has a carbon fiber texture, as you can see from the photo. The size is relatively moderate, and it is easier to install. The size of the hand in and out port is also relatively moderate, which is convenient for hand in and out. This is actually very important, because in the process of cycling in winter, it is inevitable to open and close the helmet mask by hand, especially when waiting for traffic lights. ---------------------------------------------- I chose this section of carbon fiber lines, and should be able to see from the photographs come. Relatively modest size, the installation is also more convenient. The size of hand and out of the mouth is relatively modest, easily reaches into and out. In fact, this is very important, because in the winter of cycling, but it is still inevitably a hand to open and close the mask helmet, especially when the traffic lights. Powered by Google Translator View detail
It's pretty cold.
It's pretty cold.
Recommendations for Electrothermal Gloves and Electrothermal Grips.
View detail
To run in the winter.
I have a Handlebar Guard on my Off car so I thought this was the only way to go. It looks rather large and heavy, the material is solid and hard, and the inside is made of waterproof material to prevent rain from entering. It's easy to put it on. Switch the Blinker etc.Switch operation is not the same as when it is not installed, although it is well thought out. The temperature was 5 degrees Celsius and I put on some gloves and started to test drive. I checked the fit of the Magic tape, but I judged that there was no problem. By the way, I installed NA parts manufacturer's reasonable price one on my Scooter, why I don't feel cold on that one? The only thing I can think of is that it has something to do with the inflow of outside air and the opening diameter when you install it. It is better than wearing nothing, however, because the upper part of the wrist touches the Cover when you stand in the Dirt. When the hand gets cold, it becomes an obstacle in driving operation and the accident is a source. The person of the degree of use of commuting to work and school is a necessity, and the person other than it (including me) consults with Wallet. The above View detail
I use it to commute to work.
I bought it because I couldn't stand the cold with only Grip heater. As a result, I'm glad I bought it.
No wind at all, plus the heat from the Grip heater makes my hands very warm.
The disadvantage is that the old man feeling comes out. If you use it for the commuter issue, it is all right.
View detail
Large activity in the middle of winter
The RightBrake has been replaced with radial master and the Knuckle guard can be installed by changing the position of the Knuckle guard.
You can easily remove it when it gets hot. However, it shifts in front of me while I'm using it, so I made a hole in the front and fixed it to the Knuckle guard with a few screws. I would give it 5 stars if the Magic Tape is attached to the Knuckle Guard. But there is a possibility of leaking because I made a hole in front of it.
Essential winter touring items for Off and Adventure. (personal touch)
View detail
That's what I thought when I first saw it!
It is the thing called Hand guard correspondence, but it is considerably large in the making of the texture, it is heavy, and if it does not take measures with Hand guard or Lever Guard etc. for installation, Lever may be pushed by the weight of Cover itself!
You could think of it as practically a Hand guard.
It seems to be specially designed to be waterproof, with NylonCROSS pasted on top of a frame of Urethane, and there is no special wadding or NeoBren material.
In winter, you may need to wear winter gloves or throw your Hand warmer into it to keep warm.
It's very easy to put on and take off, so if you think that you can use this one to suit your needs, you can use it in a high cost performance.
View detail
It is easy to install.
Purchased because the winter commute to work makes my hands cold until I can't feel them anymore.
It's very easy to install, just fit it into the Handlebar and tape it in place.
I installed it on my WR250R with a hand guard and was able to put it on with room to spare.
The Right Side has a zippered pocket with zipper, so you can use it as an Accessory It's useful as a case.
The WR doesn't have a USB to charge your phone, so the Right Side Pocket I put Battery in and charged the form.
The cold and windproofing effect is large and does not make your hands cold.
Even the summer Gloves were Large sturdy.
View detail