Reviews
Fits: YAMAHA Jog (2 cycle), YAMAHA Vino (2-stroke), YAMAHA Jog Aprio Type 2, YAMAHA Apprio, YAMAHA Super Jog ZR, YAMAHA JOG50 Only for vehicles before exhaust gas regulation, YAMAHA Super Jog ZR, YAMAHA JOG50 Only for vehicles before exhaust gas regulation
Purchase Repeat
Another Review The Unexpected Cooling Effect." The overall thickness of the fan is noticeably thinner than the 3WF OEM fan. (However, since the feathers are offset to be Large on the generator side, the Large size of the feathers themselves does not make much difference.)
Again, I will try to quantitatively examine the difference in Head temperature with ThermistorSensor, but I feel that 3WFOEM without Offset is more advantageous since it is a fluid structure that inhales from the inside of the fan and exhales to the outside.
Incidentally, since the wings interfere with the PALSA Coil due to the offset, a small modification is required to slightly tame the PALSA corner with a file.
View detail
Fits: YAMAHA Jog (2 cycle), YAMAHA Vino (2-stroke), YAMAHA Jog Aprio Type 2, YAMAHA Apprio, YAMAHA Super Jog ZR, YAMAHA JOG50 Only for vehicles before exhaust gas regulation, YAMAHA Super Jog ZR, YAMAHA JOG50 Only for vehicles before exhaust gas regulation
Unexpected cooling effect
I was skeptical, but I am quite satisfied with the cooling effect. The temperature dropped by about 20℃ from 135℃ with the normal fan to 115℃ with the reinforced fan. I like the sound of the Normal fan because it has a nice humming sound. View detail
Fits: YAMAHA Jog (2 cycle), YAMAHA Vino (2-stroke), YAMAHA Jog Aprio Type 2, YAMAHA Apprio, YAMAHA Super Jog ZR, YAMAHA JOG50 Only for vehicles before exhaust gas regulation, YAMAHA Super Jog ZR, YAMAHA JOG50 Only for vehicles before exhaust gas regulation
Processing is necessary!
I installed it on SUPER JOG Zr 3 YK 7, but processing is necessary! If the corner of the fin is as it is "Coil, I will interfere with PAL!" You can not start the engine with this. The ignition system will be damaged! To install it, the corner of the fin must be dropped by about 5 mm Meter. I cut out the corner of the fin into a triangle with a nail clipper. "KN project" Do you think that it can be installed without machining? Because KN's goods also have a lot of Ha GapParts "Careful attention" (Because we draw a number of Hap Gap... )
Clearly speaking the performance of this reinforced Cooling fan is not clear. "Wind pressure does not differ between OEM and Large!"
Therefore, "Recommendation can not be done. "
View detail