With Fender Eliminator and PinkNumber bared there is a sense of cheap, so we attached Black's License Plate Holder.
Since it looks like Fender if Black, I also like the Fender Eliminator Kit and I like it.
I think that it is considerably profitable that the colors of Aluminum Bolt and Bolt are also included!
What made you decide the purchase?】
Because I am in Fender Eliminator, the License Plate has been exposed and there was a fear of bending.
【How was it actually used?】
Rib is solid, there is a sense of rigidity very much, even if you shake by hands Large durable at all.
【Was it difficult to install? (Hard parts case)】
DAYTONA 's Fender Eliminator had difficulty because Nut can not be rotated unless RearCowl is removed because License Plate installation Nut is hidden inside.
【Please tell me the point of installation and hang (in the case of Hard parts)】
I think that it is necessary to check the installation state of the License Plate at the present time and install it according to it.
[Is there anything I was disappointed about?]
Although this is a personal opinion, it is useless because I bought it without confirming the spot, but I think that it was a little thick. Let's say good because rigidity increased accordingly.
【Hope for Manufacturer ? Please let me know if there are any improvement points]
There is a problem with packing. By vibrating during transportation, it seemed like White rubbed like some rubbing and I thought I was going to return it, but I decided it was probably the same and I painted it myself. If it is overseas production, I think that it will be understood by everyone that it takes time to transport, so I'd like to consider the neighborhood.
【Have you compared items?】
YOSHIMURA's Carbon License Plate Holder, but it's too expensive so I decided to do it.
Fender Eliminator Kit Purchase so that Number will not bend after installation.
Making is solid and it is sturdy. Cushion material for prevention of bibs is also included
Good. However, as Large is thick enough, processing is necessary depending on Fender Eliminator Kit
I think I will become a. In my case only a few millimeters Bolt holes do not fit and the hole is changed from - to T
Processed and installed. Because Aluminum, Drill etc. is sufficient for processing.
Based on my experience, I thought that I could easily install. However, our car NMAX 155 was fitted with the Fender Eliminator KIT, and the mounting hole of the License Plate had become considerably higher.
Therefore, it turned out that the Parts interfered with the car body and could not be installed.
Although it is making the product, although slight unevenness was seen in the Anodized processing, it is good because it is the back side. The attached BoltCollar is made like Dress-up. So I decided to use only BoltCollar.
I think the product itself is reasonable for price. It is better to check the location of the License Plate mounting hole of your car before installation.