Reviews
Fits: YAMAHA RZ350, YAMAHA XJ400ZS, YAMAHA XJ400ZE, YAMAHA XJ400Z, YAMAHA XJ400, YAMAHA XJ400D
Perfect, and just what I wanted
The caliper supports arrived very quickly all the way from Japan and the parts are of very high quality and fit perfectly. I will be fitting them to my UK 1980 Yamaha RD350LC (4L0) (also known as RZ350 in other countries) and I am very pleased with them. When I have fitted them I will attach another photo to this review. View detail
Fits: YAMAHA RZ350, YAMAHA XJ400ZS, YAMAHA XJ400ZE, YAMAHA XJ400Z, YAMAHA XJ400, YAMAHA XJ400D
Relief
I bought this because I went with brembo.
Of course, Exactly is attached, but you need to adjust the Shim to get Center.
View detail
It's a bit forced. Crying 。
This is a must have part for brembo installation.
I was not sure if it was Radial Mount or Axial Mount, but Axial is enough because it is OverQuality.
To install, just mount it on the Front fork and assemble the Caliper.
However, Aluminum Cut-out is not the same as "It's just the way it is. The feeling is ……
I think GCraft's Black Anodized Aluminum was more natural. (Sweat) 。
View detail
I think it's fine, but at your own risk.
I used it in the field where I put brembo4POD on VT250 SPADA.
The one I received is the one with no problems.
The BoltQuantity is included with the Caliper.:There are 2pc.
Be sure to check the fastenedTorque properly.
I think the Pad on the inside diameter side of the disc is slightly sticking out.
I tried to put it as far out as I could, but it was still too far. (;^ω^) It's like
What does it look like in RS?
Didn't seem to be a problem on the test drive.
It may be that it is still a self-responsibility as long as the conformity is not indicated by Manufacturer.
I don't think you'll have to spend a lot of money on Ok.
View detail
Fits: KAWASAKI ZX-9R, KAWASAKI ZZR1100, KAWASAKI ZZR1100, KAWASAKI ZXR400R, KAWASAKI ZXR750R, KAWASAKI ZXR400, KAWASAKI ZXR750, KAWASAKI ZZR400, KAWASAKI GPZ900R NINJA, KAWASAKI ZEPHYR1100
In Φ300
[How is it used?
Used in the OEMRotor300 era.
Silver, Compact and thick.
I didn't feel rigid anxiety.
Although the hole dimensions are provided, installation should be done with the Caliper on the side that it is going to move against the Fork outer during breaking and then bolt it in place.
Otherwise, the frictional force caused by the bolt tightening alone may cause the risk of gapping.
Was the one you received as per Image?
Yes
Was the installation difficult?
It's easy if you know the hang and the concept.
How was your experience with it?
OK
[Included Parts:were they on?
Yes, I was wondering if Shim was there.
[Was there anything that disappointed you?
None
View detail
It purchased, in order to attach a Brembo caliper to VTR-F. Although the Support of the Active was also good, since it seemed that there was only a PLOT, the object for one side was decided to be this. It is beautifully satisfied with the simple Des
It purchased, in order to attach a Brembo caliper to VTR-F.
Although the Support of the
Active was also good, since it seemed that there was only a PLOT, the object for one side was decided to be this.
It is beautifully satisfied with the simple Design of structure.
View detail