- Home
- Product reviews
- Search reviews
- Tools
- Instrumentation Tools
Reviews
Easy to use
The tip is sharp, and a light tap is all that is needed to firmly attach the mark.
If the Mark is shifted, the Drill hole will also be Large.
This product is very accurate and helpful.
Once you buy one, you won't be replacing it.
It is better to buy a good one from the beginning.
I can recommend this product.
View detail
For Float pin removal etc.
The straightness of the pin is good and I use it to remove the Float pin when I overhaul the Carburetor. If the angle between the pin and the hammer is not good, the pin part may be bent by the force, but it is not broken and can be used by correcting the bend. The diameter of 1.5 or 2mm is very useful for Motorcycle. View detail
Furniture easy to use Large Kimono!
This time may be different from the intended use, but I used it to remove the broken Bolt.
The center has strength, it firmly cuts into Screw, and the body part of Large Kisa with good furnishings with Round Type is familiar in hand and easy to use.
This was enough for 1 pc. (Lol)
View detail
I think that some people took pains among those who attached the Radial-master Pump of the brembo to pull out the Spring pin which grasps when attaching a Switch to a Pump probably in a preparatory step, and is fixing the adjustment knob. Moreover,
I think that some people took pains among those who attached the Radial-master Pump of the brembo to pull out the Spring pin which grasps when attaching a Switch to a Pump probably in a preparatory step, and is fixing the adjustment knob.
Moreover, work finishes on the dot in comfort in case of the tool carried out perfectly too.
If it is used by removal of the adjustment knob of the
Radial master, a tip will think that it is a Just size to the Punch which is 1.5 mm.
although the goods of 1 mm here were used this time [
], the inside of a Spring pin is entered a little, and I come out and think that
which was slightly dreadful, however the thing situation are the things which a pin spreads and meets and whose intensity may suit very.
View detail
A Holder is attached by the Set of an octagon trunk parallel Pin punch. Although the most popular use parts are printing/placing of the Retainer pin of a Brake pad in Motorcycle maintenance, It is [ to apply a shock perpendicular to printing/not onl
A Holder is attached by the Set of an octagon trunk parallel Pin punch.
Although the most popular use parts are printing/placing of the Retainer pin of a Brake pad in
Motorcycle maintenance,
It is [ to apply a shock perpendicular to printing/not only placing of a pin but the bolt head etc. which extended far back ] convenient also for the use which cannot carry out a blow directly with a Hammer to hit the Screw head which was being crushed and attach the launch pad for the Riseth correction.
Although there was also a Set with which overall lengths differ according to the
diameter, since I considered that it was easier-to-use for die length to have gathered, I chose this Set.
It is easy to grasp
octagon trunk, although heat treating and processing of a Plating are good or a tip is dramatically hard, the hardness of a blow part does not quarrel by a Hammerhead grade, but although used for years, a tip and blow part is also BALI - Turned over, and - Plating peeling etc. are absolutely none.
I think that サンメカ is a thing throughout life.
an attached Holder also tends to dissipate -- since Pin punches can always be kept by a Set, it is convenient.
View detail