Reviews
On the MVX250F.
I used it to fill the front fork with air. It's good because I can fill low pressure like 0.4 properly. View detail
Convincing texture
SizeAbout 820×I bought the one of 2000mm 。
I liked the texture of the Nylon raising on the front.
When I unpacked it, there was a smell peculiar to Rubber, so I dried it in the shade for a couple of days.
I was not sure if I wanted to go with a less expensive competitor, but I am satisfied with the DAYTONA product.
View detail
To the OH of SEROW.
I bought it because it is cheap, around OH above the waist of SEROW. Don't forget about Valve compound. View detail
Fits: KTM 65SX, KTM 250SX, KTM 125SX, GASGAS EC250, GASGAS EC200, GASGAS EC125, KTM 250EXC, KTM 200EXC, KTM 125EXC, KAWASAKI KX65, KAWASAKI KX85, KAWASAKI KX125, KAWASAKI KX250, HONDA XR650, HONDA CRF450X, HONDA CRF450R, HONDA CR85R/RII, HONDA CR250, HONDA CR125, YAMAHA YZ85
Protect your spark plugs while out riding trails
It would suck if you got stuck in the boonies because of a fouled plug and you're not carrying any spares. This case works perfectly. The most important thing is to protect the spark plugs from impacts that could change the gap or damage the tip.Not sure about larger plugs, but this was absolutely spot on for my bike plugs.It's made of a quality plastic.Really good price. Small and very secure, for longer trips. Especially when going into the local dark continents, where no one else goes. Good travels, safe journeys, and... go prepared. No one else cares, or goes. View detail
Can also be used for Mirror shield
The Mirror shield of the MotorcycleHelmet can crack or deteriorate when cleaned with aggressive cleaners, but there is no such concern with this product. The Merit of the Largeest Merit is its portability, which allows it to be brought along on day-trips. Even in the summer, water will not fly out of the bag. "Dried out." I am glad that I can use it normally without any problems. View detail
Do it once a year.
[How is it used?
I use it for Wire greaseUp on my Motorcycle.
We try to Grease up at least once a year.
Was the one you received as per Image?
It was just as Image.
However, without the Instruction Manual, I might not have been able to understand how to use it at first.
How was your experience with it?
It works fine, but it is a little difficult to do short Wire, etc.
When wire grease is sprayed vigorously, it overflows through the gaps.
[Points to note]
Not particularly
How did it compare to other products?
I think KITACO was the cheapest, although other manufacturers also offer this product.
I think the usage is the same everywhere, so the rest is preference.
View detail
Purchased for Rust removal, surface correction and chamfering.
[Usage]
Bore Up Kit BALI removal, used for rust removal, surface correction, and chamfering, Oil is Daytona Oil stoneOil.
[Feeling of use]
The size is just right to fit in your hand, but be careful not to apply too much pressure or you will shave too much. Use #400 for finishing.
When I first started using it, it sucked in Oil immediately, so I had to put Oil on it thoroughly before using it.
(Points to note)
Recommendation is to put it in a Vinyl bag etc. when storing it. If you put it on paper or cloth, it will be stained by the oil that comes out.
View detail
Purchased for chamfering
[Usage]
Used for Bore Up Kit BALI removal and exhaust surface chamfering, using DAYTONAOil stoneOil.
[Feeling of use]
Good size, fits in my hand, easy to use.
When I first started using it, it sucked in Oil immediately, so I had to put Oil on it thoroughly before using it.
(Points to note)
The Oil that is sucked in comes out gradually.
Recommendation is to put it in a Vinyl bag etc. when storing it. If you put it on paper or cloth, it will be stained by the oil that comes out.
View detail
It's firmly attached.
I had a 10mm wide tape and could have attached it side by side with sufficient strength, but I decided to purchase the Seat type because I thought a single piece would be more secure.
Some products are labeled as heat resistant, but this product is also heat resistant. Operating temperature range -20 to 150 degrees Celsius. The product is designed to withstand even midsummer in a car.
This product is slightly thicker, and its elasticity and neSpringba make it more difficult to cut out, so the cross section will be rough if you do not work carefully with a well-cut Cutter.
The adhesive is strong enough. As a basic rule, degrease the surface to be pasted firmly, and work to paste it in one shot at the targeted position.
The price seems high for Size, but it doesn't seem to fall off while driving.
View detail
Powerful
I needed to reattach the Bracket to attach the Camera to the Helmet and purchased the Seat type.
I have been using a bracket of the type that can be attached to a rec mount in order to operate a Camera that is used as a DriveRecorder by attaching it to a helmet. Previously, I was using DAYTONA's DDR-S100 attached to the helmet, so the Bracket was originally attached, but it was removed when the helmet was repainted, so it was necessary to prepare double-sided tape to reuse the Bracket. To reuse the Bracket, we needed to prepare Double-sided Tape.
Since it would be very dangerous if the Camera were to fall out of the helmet while driving, we decided to use a strong double-sided tape and a single piece of double-sided tape.
If it is for the inside of the car, we had Seat type Double-sided Tape in stock, and it seemed to have enough adhesive strength, so we thought about using what we had, but since we cannot say that there is no possibility of driving in the rain, we purchased Double-sided Tape for the exterior that seems to be strong against wind and rain, just to be safe. However, since there was no guarantee that I would be able to run in the rain, I decided to purchase double-sided tape for the exterior that would be resistant to wind and rain.
Since this product is rather thick, it would be better to use a cutter that can cut well when cutting it out. In addition, although it is a basic thing, I think it is better to clean the surface to be pasted, to degrease it firmly, to paste it in one shot at the targeted position, and not to mess with it for about one day because it is not firmly attached immediately after being pasted. As for the cutout, the cross section was rough because it was inevitably cut by hand, but generally, I think it was pasted in a good way. Since it is firmly attached, it is unlikely to be dropped while driving.
The price seems high for Size, but I am satisfied with the results as expected.
View detail
Very easy to use! Just rub!
It is not suitable for removing rust from a wide range of surfaces, but it is the best product to remove rust from pinpoints easily! It can be used not only on motorcycles and bicycles, but also on electrical appliances! Just rub it in." So I think it's pretty low threshold and suitable for everyone! View detail
Easy to use
If this product is cleaned frequently, it seems to be less prone to stains. View detail
Just in case when painting.
[How is it used?
EachParts is painted with Can Spray or other paint for TZr50RRestore.
In doing so, I found that there were quite a few paint particles flying around, which I did not notice at first.
I wear glasses on a daily basis, but I bought these to protect my eyes as well since Lens became a little safer and shinier.
Was the one you received as per Image?
It was just as Image.
It was solid like science experiment Glasses.
How was your experience with it?
I am concerned about the pressure until I get used to it, but I need it for my health, so I have to be patient there.
[Points to note]
It is quite difficult to see when it gets dark, so that's where Neck is.
How did it compare to other products?
It is more reliable protection than ordinary Glasses.
View detail
just in case one's health fails
[How is it used?
Each part is painted with Can Spray for TZr50RRestore.
I purchased this one because it is basic Blue empty maintenance, but may have absorbed a small amount of paint.
How was your experience with it?
I think it is defensive because it is held firmly around the nose and mouth.
How did it compare to other products?
At first I worked with two layers of regular Mask, but this is more mentally secure.
But inevitably the smell is going to be penetrating.
The price is inexpensive, so if it gets dirty, it can be replaced immediately.
View detail
Brake fluid replacement
Used to replace brake fluid. Until now, it was a plastic bottle. View detail
Quantity:I'd like to have it as a Set.
Straight and Curve tip for convenient use.
Grip is a little hard to hold, it would have been nice to have a thicker and firmer grip.
Apart from this, the Small Rame (Thin) It would be useful to have a Size of
View detail
At the time of Tank replacement
I used it to transfer the remaining Gasoline to my car when replacing the Motorcycle Tank.
I think it depends on the shape of the Tank, but we were able to empty the Tank almost completely with only a small amount remaining.
I could not transfer it from my car to my Motorcycle because I could not reach the Fuel Tank. (I guess it depends on the car model)
Also, the smell of Gasoline is hard to remove, so don't store it indoors after use.
View detail
Multi-purpose use
Size has two of 100? and 250?. After use, it is washed with Parts cleaner, but as shown in the photograph, when use is repeated, yellowish color is formed. This cannot be helped. View detail
Prepare just in case
We prepared just in case this was the first time we had to replace a Tire. View detail
ข้อต่อคุภาพดีสวยงาม ใช้งานง่าย View detail