Reviews
If I have trouble with Space, I will put it on.
If I have trouble with Space, I will put it on.
The Handlebar area of the revolver often has trouble with Space, which interferes with Handlebar navigation, so I'm going to solve this problem by adding this to the revolver.
View detail
Mounted face down.
[How is it used?
I use it on my Z900.
We replaced it because the other company's product we had been using was outside of the Screen, which made us uneasy while driving, and it interfered with the Screen when we fixed the phone.
Was the one you received as per Image?
It was just as shown in the Image. I thought it didn't look too cheap.
Was the installation difficult?
The installation itself is easy, but in my case, when I installed it as usual, it still interfered with the Screen itself, so I installed it upside down.
As a result, this was the right choice, and the mounted phone is now easier to see and Smooth to wear.
How was your experience with it?
It has only been running for a short time after installation, but it looks quite good with no blurring.
I will use the same product in the future in case of deterioration or accidental damage.
Attached to the bar itself is a SP Conecto Smartphone Mount and a USB×2.
If you pack it up, you could probably fit at least a WearLOVE LeCamera.
View detail
I put it on 3 Motorcycles and used it for about 3000 km.
C90CM In use for CD125Ts
There may be some interference with the Visoretc. for installation, so it may be necessary to bend or change the angle.
I have used it for about 20000 km and it is sturdy and does not bend or crack when I attach my phone and USB port.
If I had to replace it, I might not change it unless it gets too rusty or I get bored.
It is just right for general smartphone mounters to be installed.
I am using a different type for my CB125Tw and this one is also in use for about 10000km with no problems.
View detail
Installed on CB1000R (SC80) 2021
I bought this to attach my Smartphone Holder.
With Mirror mount, it is a little more noticeable.
I added Screen after this picture, so it's not so obvious.
No visible vibrations, etc., are generated.
The installation is done with Mirror, but there is no problem if you tighten it while holding down the Mount.
View detail
Be careful with thick Mirror at the root.
It's light and looks weak at first glance, but it's strong enough that it won't deflect even if you put a lot of pressure on it.
However, it didn't stick with my Mirror because it was incompatible with it, so please refer to it.
Ideas is good because you can turn it over and it can go either way.
View detail
For Smartphone Mount.
When I mounted the phone on the Ninja250R, it was difficult to see downward, so I put it on the Mirror. So I put this on Mirror. View detail
For mounting the phone.
I bought this product to install a Smartphone Holder. I chose this product because it is compact and low price.
The installation itself was co-tightened to the Mirror, but there is no problem.
View detail
Depends on the application
I use it for the smartphone folder fixation of ZZr1100 It doesn't shake by vibration and is firm After examining the fixation method using Screw in horizontal direction, vertical direction, and various places, the best position was found Found View detail
It's broken
It broke after less than a year, and the shaking due to vibration was also large I found out when the piece snapped off
After four Spot welds, I thought it was natural for this to break off, and thanks to that, my phone flew off the whole stick I went
The stick situation is also too light and shakes very well
View detail
Nice mount
This Unit GPS/Smartphone Holder Mounting is very useful if your motorcycle do not have a regular handle bar. It can combines together with the mirror. View detail
Depending on Ideas it seems likely to be divided everywhere
At first I fixed it at the root of the Clutch lever and used it to fix the ActionCam
I decided to install a camera in a different place, so a water temperature gauge ? Used as an additional Meter Bracket for voltmeter.
If there is a screw or Bolt that seems to be able to fix, it seems that it can be fixed anywhere with little processing from no processing.
View detail
good
Tightened to Meter Mounting Bracket, it was not too short, it was just right size feeling for myself
In use for smartphone installation
Cospa best
View detail
Purchase for movie shooting
Replacing Motorcycle, Handlebar Mounting for movie shooting on Handlebar can not be installed without Space.
If I had thought of what to do, I found the goods of this one with the Mirror.
I purchased and installed it for the LeftMirror side.
The installation was also very easy, and it was possible to install it without problems in about 5 minutes.
It is likely to be useful from now.
View detail
I think that it is easy to use.
I attached it to Right Side Mirror of BMW's R1200 GS.
It is an installation to make it easier to watch the iPhone.
I think that it is good to be able to slide to a position that is easy to see because the tip part is getting down..
View detail
Purchase that there is no Navigation Bracket attached
Replacing Motorcycle Replacing Motorcycle with Accessory socket Now trying to attach NavigationBody to Handlebar my Handorbar of my Motorcycle is not a normal new circle and it does not attach in a slightly changed form, Do not fit together - Ho - I was worried about the rest, but I decided that the rest could be attached to Bracket using Mirror Body and purchased it with Mr. Web, I could complete the installation.
I installed it using LeftMirror side
1 - Remove LeftMirror and adjust Bracket - - - It was a bit small, but it was a little small but I did a good job without Large width remodeling
2 - Carefully tighten the Mirror Body so as not to damage the screw thread.
3 - I aligned with Mirror afterwards and tightened.
4 - That Navigation Bracket (Purchased and used by Webmen) Attach Body.
5 - Navigation Bracket Body has gaps slightly above and below but Large As durable it will stay as it is
6 - Temporary attachment of Navigation Body and installation completed with angle as well
It is easier but I will write it as an impression
There are a few points to worry about
My MirrorPitch (8. 10 mm) to see if it is better to purchase - - - Large I did not have a problem
View detail