【Unit】GPS/Smartphone Holder Mounting Review

Mounted face down.

[How is it used?
I use it on my Z900.
We replaced it because the other company's product we had been using was outside of the Screen, which made us uneasy while driving, and it interfered with the Screen when we fixed the phone.

Was the one you received as per Image?
It was just as shown in the Image. I thought it didn't look too cheap.

Was the installation difficult?
The installation itself is easy, but in my case, when I installed it as usual, it still interfered with the Screen itself, so I installed it upside down.
As a result, this was the right choice, and the mounted phone is now easier to see and Smooth to wear.

How was your experience with it?
It has only been running for a short time after installation, but it looks quite good with no blurring.
I will use the same product in the future in case of deterioration or accidental damage.
Attached to the bar itself is a SP Conecto Smartphone Mount and a USB×2.
If you pack it up, you could probably fit at least a WearLOVE LeCamera. View detail

I put it on 3 Motorcycles and used it for about 3000 km.

C90CM In use for CD125Ts
There may be some interference with the Visoretc. for installation, so it may be necessary to bend or change the angle.
I have used it for about 20000 km and it is sturdy and does not bend or crack when I attach my phone and USB port.
If I had to replace it, I might not change it unless it gets too rusty or I get bored.
It is just right for general smartphone mounters to be installed.
I am using a different type for my CB125Tw and this one is also in use for about 10000km with no problems. View detail

Installed on CB1000R (SC80) 2021

I bought this to attach my Smartphone Holder.
With Mirror mount, it is a little more noticeable.
I added Screen after this picture, so it's not so obvious.
No visible vibrations, etc., are generated.
The installation is done with Mirror, but there is no problem if you tighten it while holding down the Mount. View detail

For Smartphone Mount.

When I mounted the phone on the Ninja250R, it was difficult to see downward, so I put it on the Mirror. So I put this on Mirror. View detail

Depends on the application

I use it for the smartphone folder fixation of ZZr1100 It doesn't shake by vibration and is firm After examining the fixation method using Screw in horizontal direction, vertical direction, and various places, the best position was found Found View detail