Reviews
Above the waistMaintenance to Stock
[How is it used?
Used for Piston installation
Was the one you received as per Image?
The product arrived exactly as shown in the product image, so no problem!
Was the installation difficult?
By far the easiest installation compared to the C-shaped Clip.
How was your experience with it?
I found it very easy to use.
Installation Point
Piston Pin side has a front and back side so that the protruding part does not hit the pin side, so do not make a mistake.
There is also an upper and lower level, so once you do the installation, you will learn it.
View detail
Fits: SUZUKI ADDRESSV100 [ADDRESS] (for CE13A only) (also compatible with CE11A-500001-), SUZUKI ADDRESSV100 [ADDRESS] (for CE13A only) (also compatible with CE11A-500001-)
Performance V100 exhaust from Chameleon Factory
Chameleon Factory chamber for V100 always the best. The welding quality aslo great! About the feeling of use after 2 years are really satisfied for performance and material quality! Last time I bought together with Chameleon belting and clutch bell. The installation is super easy. Only need to tuned the roller according to the bike. Performance increase the to speed! Really add on the power! Recommended for this chamber for upgrade your scooter speed! View detail
Fits: YAMAHA CYGNUS X, YAMAHA MAJESTY125 [Majesty]., YAMAHA BWS125, YAMAHA BWS125
Used for cuxi100
Motorcycle's initial response is fine.
I rode it for about 20 minutes and when I tried to restart it, Engine would not start.
Battery and Plug are fine.
After a while, Engine takes over.
For about 2 years without knowing the cause.
The cause was the fuel pump. It seems that when the Fuel Pump gets hot, it stops working.
Normally, when the power comes on. Whee!" and fuel pump sounds. However, it does not when it is hot.
However, if I buy these Parts and take them to a Motorcycle shop, they refuse to accept them. It seems that the entire Assembly with the fuel pump will be replaced.
It seems that you have to ask a motorcycle shop that will repair the parts by rose, or you have to replace them yourself.
I too have done a lot of searching and was helped by Review, blogs, and other articles, so I leave you with this Review.
View detail
Performs exactly as I imagined! (For better or worse.)
I diverted it to LETS II. pitchetc. it is exactly the same, so it will arrive as is. I also checked the fuel condition and there was no problem.
I used to use a NORMAL CA1KA for commuting to school and sometimes Gymkhana, but it was getting to be not enough;
Something that is not too loud.
Fuel consumption does not need to be adjusted frequently.
Manufacturer with a good name recognition
I hate Sports Exhaust.
I was looking for a "good" product, and it was Exactly, so I bought it.
Pushing up like crazy. It's probably a little bit suspicious when it rains. The welding is like a high school student's "Kiai Manji". Please be assured that it is made by Chameleon factory including those parts. (Spec.)
I was turning it up to 7,200 with a pure muff OEM product and it was about 65-70, but with Paralyzer3, WR10×3, I turned it up to 8,500 and the LimitMeter reading was 80! (So it would be about 75~ in real terms. LOL) I was able to get to Circuit, of course.
I ran it with BT601SS front and rear, but the Fork on the LETS II was too weak to stop in the first place! The Ad V undercarriage should pon in from Stem, so I'm going to replace it with that one….
View detail
Fits: HONDA Super DIO [DIO] ZX, HONDA Super DIO [Dio] SR, HONDA Super DIO [Dio]., HONDA G DASH [Dash]., HONDA DJ-1 RR, HONDA DIO [Dio] SR, HONDA DIO [Dio] SP, HONDA DIO [Dio]., HONDA Super DIO [DIO] ZX, HONDA Super DIO [Dio] SR, HONDA Super DIO [Dio]., HONDA G DASH [Dash]., HONDA DJ-1 RR, HONDA DIO [Dio] SR, HONDA DIO [Dio] SP, HONDA DIO [Dio].
Parenthesis is good
I am Large satisfied with the Race ish in both look and sound.
It seems to be compatible with bore up by adjusting Silencer's Wool, so I think it can be used in a wide range of applications!
View detail
Fits: YAMAHA CYGNUS X, YAMAHA MAJESTY125 [Majesty]., YAMAHA BWS125, YAMAHA BWS125
More reliable than OEM
It is used for CYGNUS X Type 2 Taiwan Spec.
The CYGNUS has a weak fuel pump in the 2nd and 3rd models, and it is basically necessary to replace it since it has a recall.
Fuel Pump's PRO Pella is Material:Since it is made of plastic, it can get stuck inside due to thermal expansion or deterioration, resulting in trouble when it cannot be turned.
I also had a problem once when I was on the road and my engine stopped working.
If I leave it for an hour or so and the thermal expansion stops, I can start it again, but once the symptom appears, it always recurs, so I replaced it with this product.
It seems that the OEM countermeasure is not perfect, and we have confirmed several occurrences in vehicles that have already been recalled.
Replacing the cowl is quite a large job because there is a lot of removal of the cowl and the frame is in the way, but once you get used to it, it only takes about an hour.
You can tell if this product has been assembled by listening to the sound of the fuel pump operating sound, which is quite large when the key is turned on.
I have been using it for over 3 years and it still performs consistently without Trouble.
The engine has been bored up and the injector has been changed to a large-capacity one, but I still feel a lack of fuel pressure and have not experienced any trouble.
I heard that the part number has changed due to minor changes in the past, so it's better to buy from a reliable place.
Since the failure of these parts can be fatal, we recommend that you use a reliable manufacturer, including this product, even if it is a bit expensive.
View detail
Fits: HONDA Live DIO [live dio] (mountable), HONDA Live DIO [LIVEDIO] ZX (can be installed), HONDA Live DIO [Live Dio] J (can be installed)
Nice resonator.
I use malossi sport + cdi daytona red with the cpg, the result suits me perfectly. Interesting configuration and design. I want to try the daytona cpg, I think it will be more interesting. -------------------------------------------------- -------- I use Malossi Sport + CDI DAYTONA RED from CPG, the result is quite suitable for me. Interesting configuration and design. I want to try the DAYTONA CPG, I think it will be more interesting. View detail
high capacity injector
thanks to this injector I could notice the difference at high revs it is a key product to configure the big 20% increase top View detail
Fits: SUZUKI ADDRESSV100 [ADDRESS] (for CE13A only) (also compatible with CE11A-500001-), SUZUKI ADDRESSV100 [ADDRESS] (for CE13A only) (also compatible with CE11A-500001-)
gooD
Great product , great service .easy to install, looks and sounds great.very good quality exhaust and fits nice onto the bike very happy with your item. 5 stars View detail
Fits: YAMAHA CHAMP [Champ]., YAMAHA JOG80 [Jog] Sports, YAMAHA JOG80 [Jog] Sports
I haven't run it yet, but..
The very cheap Chamber is full of bad reviews for breaking and dropping out, so it's safe to say that even if the price is a little high I went with this one The sound was better than I thought it would be, it was dry
Since there is individual difference, the Mount hole was expanded a little with File and installed
I'm looking forward to seeing how much it powers up with the Big carburetor
View detail
Fits: YAMAHA CHAMP [Champ]., YAMAHA JOG80 [Jog] Sports, YAMAHA JOG80 [Jog] Sports
I haven't run it yet, but..
Super cheap Chamber is full of bad reviews of broken or dropped out, so you can't worry about the price being a little high This is the one I chose
Since there is individual difference, the Mount hole was expanded a little with File and installed
I haven't run it yet, so I can't say for sure, but the sound was better and drier than I expected
I'm looking forward to seeing how much it powers up with the Big carburetor
View detail
Fits: YAMAHA AXIS50 [AXIS] 6.8ps, YAMAHA Met-in JOG [Jog] 6.3ps, YAMAHA Met-in JOG [Jog] 6.8ps, YAMAHA Met-In JOG [Jog] Z, YAMAHA Met-In JOG [Jog] Sports, YAMAHA AXIS50 [AXIS] 6.8ps, YAMAHA Met-in JOG [Jog] 6.3ps, YAMAHA Met-in JOG [Jog] 6.8ps, YAMAHA Met-In JOG [Jog] Z, YAMAHA Met-In JOG [Jog] Sports
No complaints ??
3KJHelmet in JOG
Center lib port 69. 7cc PWK28M (Throw40 Main135) Full digital CDI Final 8 for separate lubrication processing BW'S. 4
High Speed PulleyWeight3. 0g × 6 Others Various
If you do not make the Pulley Weight a little heavier, it will easily blow as it spins over 10,000 rpm
Street chamber is different from the time I put it in
Sound power when entering the power band is a strong word
View detail
Fits: YAMAHA Super JOG [JOG] ZR, YAMAHA Remote control JOG [Jog] Z2, YAMAHA Remote control JOG [Jog] ZR, YAMAHA Remote control JOG [JOG]., YAMAHA Remote control JOG [Jog] Z2, YAMAHA Remote control JOG [Jog] ZR, YAMAHA Remote control JOG [JOG].
Chameleon Paralyzer III Chamber [A206]
Chameleon Paralyzer III Chamber [A206] It’s Perfect! You can feel speed up and I recommend Chameleon Factory for Jog All Series :) View detail
Fits: YAMAHA Remote Control JOG, YAMAHA Met Inn JOG, YAMAHA Super JOG-ZR, YAMAHA Applio Type II, YAMAHA Remote Control JOG, YAMAHA Met Inn JOG, YAMAHA Super JOG-ZR, YAMAHA Applio Type II
Propeller
Impeller increases performance. Speeding up the speed in the early middle to make it better. More tip speed More driving fun View detail
Fits: YAMAHA JOG [JOG] 7ps, YAMAHA Super JOG [JOG]Z series, YAMAHA JOG [JOG] 7ps, YAMAHA Super JOG [JOG]Z series
Obviously hard
Previously, Reinforced Clutch Spring of externally made white color (10%Up) We were using.
With Pliers and this principle, I confirmed the strength of each other's Spring, clearly the product was hard.
So I thought that starting with Clutch meat at high revs, I thought that it would be better, and it was a wonderful acceleration that did not disappoint expectations when I installed it quickly.
And how much is the durability.
View detail
Fits: HONDA Super DIO [DIO] ZX, HONDA Super DIO [Dio] SR, HONDA Super DIO [Dio]., HONDA G DASH [Dash]., HONDA DJ-1 RR, HONDA DIO [Dio] SR, HONDA DIO [Dio] SP, HONDA DIO [Dio]., HONDA Super DIO [DIO] ZX, HONDA Super DIO [Dio] SR, HONDA Super DIO [Dio]., HONDA G DASH [Dash]., HONDA DJ-1 RR, HONDA DIO [Dio] SR, HONDA DIO [Dio] SP, HONDA DIO [Dio].
Paralyzer3Exhaust Chamber
It took a while to install the Paralyzer 3 Exhaust Chamber.
Actually wearing it and running it is realistic but acceleration has become wonderful and faster. Weight roller etc. I think that you can enjoy your favorite acceleration if you adjust
I am satisfied to buy it
View detail
It is an essential item for BigThrottle.
It is attached to 156cc of v125.
I bought it together when I replaced it with BigThrottle.
The result was Large success.
Until now it was only the controller of Mukawa river, but I was suffering every day, such as stalling and a bad turning zone.
However, we resolved all with these two points.
It was nice to really buy it.
The fuel consumption which you care about runs well even if the opening degree of Axel is considerably smaller than before, so it was about 35 kilometers away from commuting to about 32 kilometers.
It was easy and easy to install, even stopping Fuel Hose properly.
View detail