Reviews
Fits: HONDA CRF250 RALLY, HONDA CRF250L, HONDA CRF250M
Too slippery.
Crf250rally50, thank you md44 for your help, I also purchased it for the proper Position
The material of the outer skin is rough non-slip fabric that sticks to the pants like magic tape, so I can't slide my butt on it.
Regular Seat fabric would have been even better.
I have applied Silicon spray as much as I want to help my butt slide, but it still gets stuck.
It is better to replace only the Seat cover.
I like the Seat shape.
View detail
One month of use
After reading other people's impressions, I put a Garbage bag under the Seat and stapled it to the Stapler, hoping for a waterproof effect. I put a Garbage bag under the Seat and stapled it to the Stapler. (Lol) But is it necessary to do that in the first place....I didn't do this before when I used FX's Seat, so I don't know. I guess it depends on your preference, since it doesn't change the seating comfort that much when it gets saggy. View detail
Patience and energy
I am sure it would be a snap to take it out to a store and have it replaced. But they are expensive and people want to do it on the cheap... The product is great. The quality is excellent; it feels like a Yamaha type off car Seat. In fact, this is the second time in my lifetime that I have replaced my Seat with this kind of Seat, and I think that I should change it even for touring purposes because Honda OEM Seats are always slippery. Now, as for the replacement, even an amateur can do it. Without a doubt. However, if you have patience and energy...you can do it if you have a 300 yen Tucker tool from Daso and a Mxx needle. However, it is hard to pull the needle and hit the needle again and again.... View detail
Fits: HONDA CRF250M, HONDA CRF250L, HONDA CRF250 RALLY
Structural difficulties?
Here are my impressions after riding 1000km.
It was good point
The seat height has been raised by about 20mm as I expected, which makes positioning easier, and the anti-slip surface on the seat is stronger than expected, which reduces fatigue in the hips and back.
Bad point
There is a gap of about 1cm between the Motorcycle and Seat edge, and the Seat appears to be floating.
Also, the screw holes were so gapped that they could not be seen and needed to be adjusted. (I didn't see this in any other reviews, so maybe mine was just ha-gap.)
View detail
Fits: HONDA CRF250M, HONDA CRF250L, HONDA CRF250 RALLY
For Touring
I purchased this for my CRF250M that I use for commuting and touring.
Originally, I installed a Gel Zab and Positive drive on top of the Normal seat to reduce the load when riding for a long time. The first Gel Zab was not very effective, so I immediately replaced it with Positive drive, and it became a little easier to ride.
After all. You might as well change the whole Seat." and went to Complete high seat.
The Seat surface is a little wider and the Seat height is higher than NORMAL, but the footing did not change since the Seat was originally ridden with Gel Zab and other equipment installed on top of the Seat.
After riding it for a while, my impression is that Very good." It is
Seat is less slippery. (Grip.) I think people have different tastes in terms of points.
View detail
Nice, better than the original seat
Its goodlooking and very good quality. The fitment is perfect on my honda 250m. iS HIGHERLY recomended for all this honda model View detail
Fits: HONDA CRF250M, HONDA CRF250L, HONDA CRF250 RALLY
The anko might be cheesy.
I bought this to improve Position and change the look of my Motorcycle.
That was perfectly correct.
But the bean jam inside was normal, both good and bad.
View detail
Fits: HONDA CRF250M, HONDA CRF250L, HONDA CRF250 RALLY
CRF250M footpegSeat installed
To be honest, I was worried about the price until I decided to buy one. I was also worried about whether I should get the high seat or the footpeg seat. The reason why I decided to go with the footpeg seat is because the High seat has a shape that makes the seating position too far back, and also because it just doesn't look good after installation.
This is my impression when I installed it (I am 180m tall and weigh 75g). The seat height has been raised enough. My knees were bent and both feet were sticky, but now my knees are extended and my feet are floating a little more than sticky.
The riding position used to be a bit cramped, but thanks to the extended knees, this has been eliminated a bit.
I don't know how much the seat height is actually increased, but I personally think it became a good feeling. And unlike the Normal seat, the seat doesn't slide back and forth when accelerating or braking, so I can drive with a good feeling.
from now on [Spiral's Seat is hard. But I don't care that much about it. It's just a personal subjective feeling, so it's different for each individual, but I think it's just right for me.
Honestly, if you're worried about the price, I think you should buy it. No, I get it...you're paying 30,000 for a….
The satisfaction after installation is also high, and the custom look is increased when the Seat is replaced. You'll be noticed. I think. I think it is more effective than the fancy Stickers.
View detail
Installation review
The higher seat position makes driving easier Because it is softer than the original seat, fatigue is less accumulated even on long-distance driving. View detail
Fits: HONDA CRF250M, HONDA CRF250L, HONDA CRF250 RALLY
This Seat is for Off-roadMOTARD!
We are the inimitable MotocrossMOTARDFreak.
I've installed Spiral's High seat in all of the vehicles I've owned of that type, so there's no doubt about the performance anymore!
The fit is not right for some reason only for 2012 crf250l.
Well, I didn't mind too much because I'm performance oriented.
View detail
A little bit pricey, but a good product
This is my first Seat Replacement
I bought a Tucker from Home Center and they said it was not waterproof Put it in a plastic bag and temporarily fix the top and bottom before placing it in Quantity:Pair (for Left and Right) And then I packed it in
Draping made it easy to reupholster for the first time!
With the Protector, it is easy to front up on cars that are off, which is difficult to grip the knee became
I was unsure about the OEM BlackSeat, but this one was good because of its grip
View detail
It got easier to ride
I tried Seat stretch for the first time.
Because it does not fit properly with Daiso Tucker,
I pushed it in Driver and stopped it.
As Seat cover is exclusively for the car type, so it is solidly cut
It was easy, because the tip of Tank side was also Draping.
The impression which got on grips more moderately than the OEM, but SIDE
OEM same etc. Because it does not disturb the operation with ease.
I thought about OEM's BlackSeat, but in this case
It was a correct answer..
There is no impression, but it is a good item.
Those who are considering it is recommended.
View detail