Reviews
Fits: HONDA glom, HONDA MONKEY125, HONDA DAX125, HONDA HRC Grom, HONDA HRC Grom, HONDA NSR50, HONDA NSR80, HONDA NSF100, KAWASAKI Z125 PRO
KITACO Axle Protector Set (color black)
About quality and texture - Build quality is always top notch with Kitaco. Great craftsmanship always. Difficulty of installation - Installation is very straight forward and easy, just slide axles out and install with provided washers. Cost performance and comparison with other products - Very affordable. About shipping and packaging - Packaging is well packed and secured. View detail
To the Accent around the Rear tire
This is the accent as seen from the rear view. View detail
It is easy to install.
Installation takes only one minute! View detail
Fits: HONDA glom, HONDA MONKEY125, HONDA DAX125, HONDA HRC Grom, HONDA HRC Grom, HONDA NSR50, HONDA NSR80, HONDA NSF100, KAWASAKI Z125 PRO
Can also be used with Hollow Axle Shaft.
The name is "Axle Protector", but I installed it as a stress-up part because I thought there was not enough red around the front tire rather than to reduce the damage of the vehicle at the time of a fall. I already had an experience that I had a hard time to put in the Shaft when I removed the front tire by replacing it with KITACO's Hollow Axle Shaft, so this time I used DAYTONA's Maintenance Stand for Front. I was able to insert and remove the shaft easily because the vehicle weight was not applied. I think it is difficult to install by DIY because the fork hole, collar, and wheel are not aligned unless I lift up the maintenance stand or the handlebar, etc. I am satisfied with the red accents around the front tires, which are mostly black parts. View detail
Increased sense of Torque
Installation is easy, as it is just a matter of fitting it into the Frame and tightening the Bolt1 pc.
The simple structure makes it easy to replace or repair.
The effect can be seen as soon as you start running.
It feels as if Torque has been increased.
View detail
It didn't work
I tried to install it, but I have it set to short suspension.
What a surprise, Chain didn't hit Roller ….
I will try to install it again when I change to Normal suspension.
It would have been nice if you could have written something about not being able to use it if it's Lowdown.
A little disappointing.
So we do not know the effect of the installation.
View detail
Fits: SUZUKI Hayabusa, SUZUKI GSX1300R HAYABUSA, SUZUKI KATANA, SUZUKI GSX-S1000, SUZUKI GSX-S1000F, SUZUKI GSX-R1000, SUZUKI GSX-R750, SUZUKI GSX-R600
Axle Block
It's a little expensive, but it's cool! View detail
Suzuki chain adjuster
Item landed.once again,very proud of webike.excellent job keeping the package safe.packing is excellent.product is as advertised.the product is solid,clean machine cut.super awesome logo.my 4th purchase from webike.. highly recommend. View detail
Fits: YAMAHA YZ450F, YAMAHA YZ250F, YAMAHA YZ250, YAMAHA YZ125, YAMAHA WR250F, YAMAHA WR250R, YAMAHA WR250X (MOTARD), YAMAHA WR450F
It's a very simple component, but it's very austere.
I replaced it when I converted WR to MOTARDSpec. I increased the number of teeth on the DrivenSprocket by one tooth, so I checked if I could go with the same number of chain pieces only by adjusting the position of the axle shaft, and I managed to do it. I was able to adjust the chain slack by looking at the service manual by myself. It's not so simple, but it's quite nice. I like it. View detail
Fits: SUZUKI Hayabusa, SUZUKI GSX1300R HAYABUSA, SUZUKI KATANA, SUZUKI GSX-S1000, SUZUKI GSX-S1000F, SUZUKI GSX-R1000, SUZUKI GSX-R750, SUZUKI GSX-R600
Red color stands out.
The price is high, but YOSHIMURA has done a great job. It is an excellent product for dress-up. View detail
Is it a fake? I don't know.
The Instruction Manual is really minimal, but the distance to the Chain is adjusted by Washer, etc., so beginners must be putting it on the wrong way. View detail
Fits: YAMAHA WR450F, YAMAHA WR250F, YAMAHA YZ450F, YAMAHA YZ250F, YAMAHA YZ250, YAMAHA YZ125, YAMAHA WR250R, YAMAHA WR250X
Easy to read. Looks awesome. Better than factory in every way
Great product.This makes the hashes so much easier to read. No more breaking out a tape measure everytime you adjust the chain. Was also able to figure out my hash marks on the swing arm do not match left to right. Drastic improvement for function over oem. Bought these to replace the mis-matched axle blocks that the installed on my friend bike. The colored anodized finish make these look trick, while they fit perfect and are easier to read than the standard blocks when adjusting your chain. You can also reverse them to get additional fore-aft adjustment if needed, and at a great price. The stock adjuster blocks tend to pivot when tightening the axle nut. These blocks are made with tighter tolerances so they don't rock when tightening the axle nut. This eliminates any doubt that the chain alignment marks are the same. I have over 50 hours on them and they are holding up great. Webike too fast.Thank you also for the fast shipping and nice packaging. View detail
Fits: HUSQVARNA TE125, HUSQVARNA TE300, GASGAS EX250, GASGAS EX300, GASGAS EC300, GASGAS EC250F, GASGAS EC350F, HUSQVARNA FE501, GASGAS EC250, HUSQVARNA FE250, HUSQVARNA FE250-501, HUSQVARNA TE125-300, HUSQVARNA TX125, KTM 530XCF-W, KTM 530XC-W, KTM 125-530XCF-W, KTM 125XCF-W, KTM 530EXC-F, KTM 125-530XC-W, KTM 125XC-W
Great way to ensure adequate chain adjustment,Blue matches Husky
Previous owner installed some cheap aftermarket aluminum axle blocks which were too narrow and malformed when torqued to spec. bought these for my friend and they fit great and work perfect! Cant beat the price either.Stock blocks were worn out and damaged, these Zeta blocks were an excellent replacement.I picked these up because zeta usually has good price to quality ratio and they work perfectly. I can torque my axles to spec and no malforming in the aluminum. This makes the hashes so much easier to read. No more breaking out a tape measure everytime you adjust the chain. Was also able to figure out my hash marks on the swing arm do not match left to right. Drastic improvement for function over oem.I'm glad to doing shopping from you , Thanks for fast shipping.Highly recommened. View detail
Fits: HONDA glom, HONDA MONKEY125, HONDA DAX125, HONDA HRC Grom, HONDA HRC Grom, HONDA NSR50, HONDA NSR80, HONDA NSF100, KAWASAKI Z125 PRO
Good product
It not only protects the Axle Shaft in the event of a fall, but also hides the Axle Shaft Bolt for a stylish look. Quantity for Rear:I purchased 1 Set and bought another for Front. View detail
Fits: HONDA glom, HONDA MONKEY125, HONDA DAX125, HONDA HRC Grom, HONDA HRC Grom, HONDA NSR50, HONDA NSR80, HONDA NSF100, KAWASAKI Z125 PRO
Good for dress-up
When we switched to KITACOAxle Shaft this time, we also installed this Protector!
I was torn between this and other Manufacture's products, but the Black color and not too flashy was the deciding factor!
I think it would be safe in case of a fall.
Mounting is both front and rear.
View detail
Fits: HONDA SUPER CUB110, HONDA SUPER CUB110, HONDA CROSS CUB50
ShininglyMaterial:Stainless Steel
The screw thread of the Chain Adjuster was stretched and felt stuck, so I purchased a Posh product from Other Brand Product instead of OEM.
Adjuster part is longer than OEM, but it is easy to replace.
Shiningly shining Stainless Steel is a nice touch.
Chain is small, so check it often and tighten it at the proper torque.
View detail
Fits: SUZUKI GSX750S Katana, SUZUKI gsx1100s katana (sword), SUZUKI GSX750S Katana, SUZUKI gsx1100s katana (sword)
Stainless Steel Chain Pull
Installed in conjunction with KATANA's suspension Refresh. It looks onliy, but I am satisfied with it. View detail
Aluminum Chain Adjuster
The genuine parts are rugged. However, this product has a neat appearance. I highly recommend it to those who want to get a dress-up of the chain adjuster. It also has the advantage of being able to adjust the chain with hexagonal wrenches. View detail
Fits: SUZUKI Hayabusa, SUZUKI GSX1300R HAYABUSA, SUZUKI KATANA, SUZUKI GSX-S1000, SUZUKI GSX-S1000F, SUZUKI GSX-R1000, SUZUKI GSX-R750, SUZUKI GSX-R600
I refurbish it every time.
I am infected with the Suzu fungus and I like YOSHIMURA, so I install it every time I change my Motorcycle.
Adjuster's adjustment cost usually increased, but there was no change in GSX1300R HAYABUSA.
Material:It is aluminum, so it can't be helped, but it is easily scratched if handled roughly when threading the Axle Shaft.
View detail
Swingarm Paint Protector
Cheap upgrade to not damage good paint on your swing arm with your restored 4mini bike. Protects the paint when you adjust the chain or change tyres. Also looks great and it's very well made with good detail and finish. A+ View detail