- Home
- Product reviews
- Search reviews
- Motorcycle Parts
- Drive Parts
Reviews
Good looking
This clutch oil tank support with brembo oil tank look simple and the oil tank position is just right, not too high not to low.Good looking. I buy that with brembo rcs14,that is pretty match. When you know how to bleed the air , the installation is not too much difficult . That is little bit expensive but i think the looking is better than brembo . Webike shipping is fast and packaging is good. View detail
Simple design and the best product.
[How is it used?
The Brake Side is also made by the same PLOT. Oil tank stay Brake S50 only introduced. Part numbers are. BPS001SB It is
The clutch master cylinder is of course brembo's 19RCS. The clutch master cylinder is of course brembo 19RCS.
I was looking for something simple, low height, and black, and PLOT's Bracket was right in the middle of my criteria.
Was the one you received as per Image?
The Mount will be exactly as shown in the second product image, Mount Image! It is perfect.
Black color is paint or cation, Material is probably Stainless Steel.
Included Parts:is also all in black, so it was Exactly the XJR around the Handlebar in pure black.
Was the installation difficult?
It is not difficult to do. It comes with an illustrated Instruction Manual, so you will know immediately what to put on where.
One point is the orientation of the Bracket, but since there is no indication of which is the Tank side and which is the Master side, I was a bit confused for a moment.
How was your experience with it?
I have included a picture of the installation and it turned out to be the best Mount.
But! There is one caveat. I'm sorry I overlooked it myself...
This Bracket is made by brembo. Oil tankS15B only." This is the case
S15 "B" This is important.
The oil tank I had installed was S15A. yes, the angle of the outlet is different.
S15A→ with angled outlet
S15B→ ejector Straight
As it turns out, it did not stick. I was able to cut and install the length optimally because I also bought a new Hose.
However, the Nipple on the Master Cylinder side has become a little overloaded, so the Oil tank was removed as soon as possible. "B" We plan to change the name of the company to the one in the following table.
[Included Parts:were they on?
It is as shown in the picture. The thinner Washer was described as being for interference prevention, but I think it is too thin and will not come into play.
[Was there anything that disappointed you?
As a note, I was a little concerned about the angle of the oil tank, so I bent the bracket and the paint cracked. It is not a defect of the product or anything, but it is unavoidable because of the excessive force applied.
View detail
I've replaced it with a brembo Clutch.
I replaced it with this product because I replaced it with a brembo clutch lever.
If you swapped to a bremboClutch lever, you can't go wrong!
View detail