Reviews
Fits: HONDA DAX125, HONDA MONKEY125
Room for improvement
This set comes with a connector to avoid cutting cables. Unfortunately my 2023 monkey did not have the connector in the pictures nor anything remotely resembling the connector layout. Had to cut cables, sadly. I managed to slightly round one of the handblebar bracket bolts from the set while tightening.. with a small ratchet. The bracket itself and the USB connector are nicely made. Back light is green. The cap seals nicely and gives confidence in water resistence. Manual is japanese. View detail
Necessary for extending power lines!
This wire is needed for the power line for DAYTONA's Radar to be a direct out instead of USB.
The KITACO power supply extraction unit is placed under the Rear Sets and wires are extended from there to the Front.
Wiring is a hassle, but once it's on, it's perfect!
View detail
Separate handle car may be hard
I bought it to install on my Ninja ZX-25R, but there was no suitable space around the handlebar, so I gave up the idea of installing it.
I tried to attach it temporarily to the Multi Bar Holder, but the Unit is too big to be attached to the Handlebar.
Parenthesis bad, so I gave up completely.
However, it was a waste, so I installed it on my Ninja 250R.
The Ninja250R already had a USB power supply from another company installed, but we decided to replace it with this product.
The Ninja 250R handlebar has plenty of space to accommodate this product, so we were able to install it without any problems.
I installed it on the Left Side of the Handlebar, not sure if it will fit on the Right Side as I haven't tried it.
The installation went without problems because the ACC power supply was already branched.
No... there was one problem:the Male Bullet Terminal was already crimped, but the Bullet Terminal did not meet the standard.
I had to replace it with a Bullet Type Terminal that I have. It seems that the Smallest Bullet Terminal is used halfway.
View detail
Compact
Purchased because my previous New Ing USB power supply was disconnected.
Cover of the terminal is Material:I wonder how waterproof it is because it is plastic, but it looks better than Rubber cap.
The power supply is a bit large, so the installation location is a bit of a consideration...
With CROSS CUB, there is room in the body, so mounting is not so much of a problem.
The cord has a Connector, and if you place the Connector on the Battery side, you can connect DAYTONA's corresponding Charger, but it must be connected directly to the Battery.
View detail
I would recommend the New Model for its appearance.
It seems that the optional Battery charger and Cable can be used together, but the Connector did not fit unless the part number was confirmed.
The plastic part of the connector is too large, and it is difficult to pass through a thin part.
In my case, I could hide it under the Bar pad, so I don't mind, but I think the company's Vertical Type looks SMART and better.
View detail
One per unit
I chose this MAJOR product because a Smartphone Holder and USB power supply are necessary at any rate.
Power is taken from DAYTONA's License lampCoupler 2-pole (99888), connected to the standard DCJackCoupler for Option.
I was wondering where to put the transformer when installing it, but since my XSR is equipped with Visor, I tentatively installed it on the CouplerHolderCover behind the Light.
View detail
Slightly oversized charging Cable
Used in GSX-R1000R 2016
In other words, it is simply a USB Cable.
The company's Battnao USB Power Cable (15644) The Indicator's LED, cap, and other features are too large to be a simple USB cable.
It is not merely functionally excessive, but as it looks, it is also physically wastefully Large.
However, as you can see if you look for it on Amaz*n, it is actually hard to find a One SideL-Type USB Cable with USB-C terminals at both ends with this length.
Therefore, even if we exclude the fact that the USB cable itself is large, the USB cable itself in this packaging is currently valuable.
Further narrowing the choice of USB Cable is the company's USB power supply with USB-PD support (17213) It is
Not only is the terminal USB-C, but the insertion slot is narrowed, and a USB-CCable with a volume at the terminal cannot be inserted all the way in due to interference with the insertion slot.
I went through several cheap Chinese cables on Amaz*n, but the one with the right length/terminal shape somehow had a large terminal size, so I could not use it because it did not fit in the limit.
However, as expected of the same manufacturer, this product can be used without problems.
So, the company's USB power supply with USB-PD support (17213) If the power supply is routed around the Handlebar in the "Power Supply", this product would be the best solution as a Cable between the power supply and the smartphone.
Although the price is slightly higher, there is also the aforementioned terminal Size, and Amaz*n has a no-go CableQuantity.:Available at Cost to buy 2pc.
The next question is whether the excessive terminal Size is acceptable.
BaddaDirect USB Power Cable (15644) If so, they should have included a clamp to hold the tip. I don't know....
Nevertheless, if this head start and the price are acceptable, I can fully recommend this product.
View detail
It is more Compact than I expected.
I purchased this product because when I installed a new navigation system, the power supply was specified to be from Cigar.
However, I did not install it in Motorcycle because I modified it to be able to get power from USB after all.
Since it is a USB + Cigar socket, I was expecting a large body.
I thought it would not be too much of an obstacle even if it was installed around the handlebar.
I thought
From now on, I will attach it to a 12Bolt power supply in my home to check the operation of Motorcycle's electrical components.
I will use it as a Tool.
View detail
charging
I was looking for something good for charging my cell phone, and this one had good reviews and was not too expensive, so I bought it.
Power saving, Compact, Waterproof is good, will I use the Charger connection? I don't need it. I don't think many people will use it.
Is constant connection a subtle use of power or does it raise Battery? It is a hassle to disconnect, but I would like to see how it goes for a while.
View detail
Great design, bad quality
I do like the concept and the design. This item is not durable because the quality of the cable is poor. It is a very soft cable. All the cables in this device are too thin, not much copper, low AWG. The jackets of the cables are also thin and soft. The box containing the circuit has a rubber gasket, which is nice, but the holes for the cables are not weather sealed. The other problem with this is the USB-C port, which doesnt hold plugs snugly. I tried with different cables, all plugs fit snugly in my phone, but too easy to remove from the Daytona charger. Also the rubber protection plug is too easy to unplug by accident. At first I liked a lot this design, because it has a separate power supply unit, which makes the outlet very small and convenient. But the cable between the PSU and the outlet is too short. It was a pain finding a way short enough for what I needed, because you have to install this little PSU box in a cool and dry place. Anyway, It was a big job because I found a place for this box inside the fairing panel (I had to remove 4 panels to reach this place). The installation was a success. The result is great, but I am sure this device will not last much, because of the poor quality of the cable. It is just a standard phone charger cable, low AWG, soft jacket. Because it moves whit the steering wheel it should have a good quality cable (higher AWG and better plastic jacket). The price is good, the quick charge mode works good, but i will have to replace this soon because the cable will not last. It is a shame Daytona have great designs but they make bad products because they use cheap materials. I would happily pay twice the price if this had a good quality durable and longer cable, a better quality power supply box and a better quality outlet with a solid snug fit. View detail
I bought it because I'm going to use it for a long time.
I had a long ISB cord attached to a handlebar with a 5V converter USB socket from the attachment power supply, but that was enough, but I bought this because it will last me a long time.
For the power supply, you just need to buy a Harness that you can get from Headlight and connect it with the Kiboshi terminal on it. If you know how to do this, you can attach it quickly and easily.
You get a stable 2.1A and, well, the Socket is good like that.
Precautions for use
*The constant connection consumes a small amount of power. Please remove the intermediate Connector for long-term storage."
Some people are using a direct connection, but it is written that it eats a small amount of power. Even if you do not connect any device to the transformer, the 5V USB transformer is probably eating a small amount of power.
So, it is written that if you remove this Connector, you can connect and charge DAYTONA's Charger, but there may not be many people who use it.
View detail
I can charge my phone.
I installed it because I can charge the battery when I am touring. View detail
USB is convenient.
I checked the Plain Type Terminal of the Brake switch and found 13.8V, but there was no voltage at the USB outlet even though I connected this product, so I used the KITACO Power Supply Unit that I purchased separately to connect the Wiring. I don't know if the voltage was not coming from the earth of the Both Sides of the car, or if there was not enough current in the Brake switch, but I put together the ready-made parts and the connection was completed. View detail
Improved convenience
Asked Shop to install. It is very useful for charging my cell phone and Grip heater. It's a big difference between having it and not having it. I think it is an indispensable item. View detail
It did not last a year.
It lasted only a little over a year.
The Large body seems to break after the manufacturer's warranty expires.
The Cover disintegrated while running, probably because it could not withstand the vibration of the single cylinder.
Before that, the Tube Fuse had rusted, causing poor contact and loss of power.
When I disassembled it and looked inside, I found it was rusted, so I think the waterproof property of the original Cover has never been Large.
The current flow itself is still present, so I crimped it with Shrink Tape and wrapped it around with Insulating Tape.
I think it is probably more waterproof than the original.
I do not have a Repeat. If I do buy one, it will be the 2-port one that attaches next to the company's Switch Box.
View detail
For fixing USB power supply cord
I used to disconnect the cord when not charging my phone, but it became a hassle to put it on and take it off each time, so I installed it.
It's okay if you don't need it, but...
I would recommend it to anyone who is looking for a hassle-free experience (laughs).
View detail
It is hard to see the energized indicator when outdoors.
I bought a new Cable because I changed the power supply to a USB-C one when I changed my phone model.
The connector on the LIGHTNING side is L-shaped, so I chose this one. The connector part is tough, and it looks sturdy to say the least, but you need to be careful about interference with the tank.
The connector on the LIGHTNING side has a white LED Lamp that glows when energized, but outdoors, it is almost impossible to tell whether the LED is lit or not.
I think it would have been better to remove the LEDs and make the Connector smaller.
View detail
For Grip heater
I always use this because it is easy to install, although it is battery-direct.
I use it for Grip heater for wrapping.
View detail
There is not much difference in price between a bite and two bites.
The price difference between one and two mouthfuls is not much, so two mouthfuls are purchased and fitted.
Since we had previous experience installing this product, we were able to install it without difficulty, even though there were differences in considering the wiring path and mouth mounting points for that model of car.
If possible, I would like to see a Bullet Terminal included as well as a direct Battery terminal.
View detail
Compact
Compact, so the Handlebar area is clean. View detail