【DAYTONA】12V Power Cable for MOTO GPS RADAR Review

MOTO GPS RADAR 12VPower Supply Cable Installation

I like it because Body is activated by key ON.
I bought it once before for my Body and installed it myself,
The voltage converter was attached to the car body with double-sided tape, but before I knew it, it was ha-gapped.
It looks like it was broken by vibration and the electricity stopped coming.
For a while, it was powered from USB,
I still repurchased and installed it for its waterproof property.

This time, I fixed it properly with Tie Band. 。 What is the result?

Power is taken out from the D-UNIT.
Wiring is necessary to consider the movement of the handlebar (depending on where the body is mounted) and to handle the wiring around the handlebar.
If you want to remove the Cowl with Wiring handling,
To identify the location and type of bolt (write the number on the cowl or put a plastic tape on it).
Bolts that have been removed should be inserted through holes in the corrugated cardboard in numerical order so that they are not lost.
Be careful not to leave Bolt behind for restoration! View detail

Can Refreshing Wiring

I can connect the GPSRadar detector's supply power supply cable directly to the power supply so I can refresh it, but I wonder if it is a bit pricey.
Since it is not taken from USB, the power supply circuit can afford to be more flexible, so powering a smartphone is no problem. View detail

Could be a little cheaper.

The neatest way to power the MOTO GPS LASER from the Attachment power supply that is linked to the key ON is to use this from the OEM. If possible, I would like to see this attached to the Body as Included Parts:instead of USB.
The 12V→5V conversion and the Fuse are only for the body connection part, but 3800 yen is expensive. The waterproof connector is a waterproof connector, so we have no choice but to use it. It is not good in terms of cost performance. View detail