Reviews
ease of use
Very easy to handle. View detail
Windproof effect + does not destroy Style + makes cleaning easier
I have an OEMHigh Windscreen, but when I replaced the Helmet, the Wind Cutting noise became worse.
The wind was now coming from the upper half of the helmet, but if the Adjuster is raised to the Largeest setting, the wind is no longer coming from the helmet at all.
It is easy to install, and if the adjuster is lowered, it hardly disturbs the style.
It was also good to have space between the Screen and Bracket, making it easier to clean.
The disadvantage is that it is not possible to put something like a Screen Mounting Bar Holder between the Screen and Bracket due to the installation, and the price...
View detail
Nice touch - but problems for yourself
Installation is a nightmare. You have to remove your whole tail assembly except you subframe. The new undertray comes with battery slot, but misses some of the grooves required to route wire harness. Putting back the tank had challenges. Fitment is ok. View detail
It's fine without it, but it's not tight enough without it.
[How is it used?
Mounted on Archi's Seat
Was the one you received as per Image?
It was just like the image.
Was the installation difficult?
Not difficult, but since the length is Limit, Bolt tightening while pulling a little.
How was your experience with it?
Without it, Seat's Balance looks bad.
[Included Parts:were they on?
Mounting Bolt only
[Was there anything that disappointed you?
Nothing in particular, but I wish it had been included instead of sold separately.
View detail
fairing
not bad looks good arrived with a few little chips on edges used some black touch up .and now you can not tell they were there View detail
Way better than rubber rim strip
This makes life so much easier when changing tires. I no longer have to worry about the rim strip moving on me when trying to put the tube in. I like this better than the rubber cover that wears and slides off the spoke ends. You have to clean the rim very well, I use brake cleaner. I change tires a lot and these have been working great. Rubber strips leak, some other strip tapes did not hole up as well. I'll use this again. Worth the extra money.i definetly recommened. View detail
fender eliminator
I received the package in very good condition, both on the outside of the packaging and on the inside, well protected and on the agreed date. The bike takes on a better street style, since with this fender eliminator you can better see the rear rubber View detail
Nice windscreen..completes the look of the new katana
Good looking and proper fitting windscreen For the new katana. I think it looks way better than the small original screen. it even helps a bit at highway speeds Up to 120kmph.or 70mph. View detail
Fits: HONDA PCX160, HONDA PCX125, HONDA DIO110, HONDA LEAD125, HONDA ADV160
White stands out.
It will be Accent on Black tasteless Smart key.
It's also good that you can't mistake it for a spare key!
View detail
It seems to be more durable than OEM.
It was firmer than OEM and seemed more durable.
Since these are completely self-satisfied Parts, there is little need to replace them unless the OEM Mud Guard runs out or something, but I replaced them out of self-satisfaction.
View detail
Meter visor installation
With the right tools, it was not too difficult to install. Maybe a larger size would be better for wind protection. View detail
Fits: SUZUKI Gixxer SF 250, SUZUKI Gixxer 150., SUZUKI Gixxer 250
Impression after 2 years of use
There are 5 different types of carriers for the Gixxer 150 that are always available, but others are too tough, too weak, too expensive, etc. This one is made of a sturdy material and is good for refilling. The others are too tough, too weak, too expensive, or too many other things, but this one is made sturdily and is good for refreshing.
The material is solid and does not shake even if a 40L~ear box is attached. I am generally satisfied with it.
But this is the point of … I dare to write!
Material is not very good, and even with the cover in place, the rain still soaks in and keeps it wet, so the rust is noticeable, especially in the cherubs that are written under the box. The rust is not noticeable if you don't look into the box because of the location.
The ? front side tip of the Cap is easy to remove. The front side was lost without my knowledge. The remaining Right Side can be easily pulled off by pulling with fingers. The Right Side is probably lost, but I think it got caught and fell off when I pulled it toward me to remove the Saddle Bag. One day, I found a black round disk on the Garage. I don't know. I found out when I was storing it. I pulled out the remaining parts on the Pipe with the broken lid and attached them with glue, but they seemed to come off again, so I used a chair cover instead.
?This is the best It's kinda…" I have a Spacer and a Carrier, but if left unattended in a downpour, water will definitely get inside. I think it is probably opening too much for the Saddlebag Support Plate that can be attached at the same time. I'd better think of a way to block it.
View detail
Stack Belt just in case
I have installed it on my KLX230R and do not want to be too much help, but I installed it just in case because the ease of pulling the motorcycle is completely different without the Stack Belt when I need help on forest roads or in difficult areas.
TrekField's Stack Belt does not require any particular Fender to be removed, so it can be easily attached.
I think it is more likely that it will not be used in most Cases, but in case of emergency, the Stack Belt would be a great way to respond to the kindness of your friends.
It is the Stack Belt of a Large person's taste.
View detail
Fits: HONDA DAX125, HONDA MONKEY125, HONDA CT125CT110 HUNTER CUB
Parenthesis OK
I think Parenthesis looks good. It is easy to install, too. The double-sided tape is visible from the outside, and it bothers me. I didn't notice it at first and ended up using a different double-sided tape to reattach it. Other than that, I have no complaints. View detail
The design and shape are good, but the gap for the tank pad is unavoidable.
The design and shape are good, but the gap for the tank pad is unavoidable. Although I purchased the product with an understanding of this gap, it bothers me a little. View detail
Fits: KAWASAKI ZZR1400, KAWASAKI ZX-14R
Well-designed Rear suspension will be protected from dirt.
It seems to protect Rear suspension from dirt with good design.
Because of the tie band fixation, some adjustment may be possible when wearing.
View detail
![[K-CON Pro] License Plate Base](https://img.webike-cdn.net/catalogue/images/69385/0901-657-00050b0_TS.jpg)
License Plate Base
License Plate was installed to prevent bending and staining.
The size is exactly the same as the License Plate, so it fits nicely.
I would have liked it to be a little lighter in weight.
View detail
Sharp Reflector
The ReflectorSticker in the Included Parts:of the AELLAFender Eliminator Kit was not good, so I was looking up Reflector on the website and found this product.
I liked the casual design under the License Plate.
View detail
Pillion Bar installed (XJR400R.99)
There is some shaving of the OEMFrame, but it was not that difficult to do. The installation method was also easy to understand if you read the instruction manual that came with the product. It took about one hour because I was not familiar with the shaving process. View detail
Fits: KAWASAKI Ninja H2 SX, KAWASAKI Ninja H2 SX SE
Speedra Carbon Tail Light Cover
The OEM ABSTail Lamp Cover is cheap, so we changed it to …Speedra's Carbon Tail Light Cover!
The texture will be much better.
View detail