Reviews
Exhaust pipe dizzying
[How is it used?
The YZF-R25 is now being racerized with a BEAMS JP250 exhaust pipe.
O2 Sensor is no longer needed due to the introduction of RapidMotorcycleRACING, so this product was introduced.
Was the one you received as per Image?
It was exactly as shown in the picture. I felt that the length was a little long.
I think that the protruding part of the Bolt may be too exposed on an exhaust pipe with a low boss height, which may cause exhaust resistance.
Was the installation difficult?
Gasket is also included, so be careful not to forget to install it.
How was your experience with it?
Gasket is included and is working well with no exhaust leaks.
I am happy with the price because other Manufacturer's products are ridiculously expensive.
The O2 Sensor Blind Screw is loose in the Large body. Therefore, it was necessary to be able to do Wiring.
When you install it, don't forget to retighten and wiring.
Also, since Size is not mentioned in the product description, it is included for reference.
Screw Diameter:M18
Pitch：P1.5
Length:23.5mm
Wiring hole diameter:1.5mm
I don't know what the Material is, but it is something Brass-like. (Laughs)
[Included Parts:were they on?
One Gasket is included. Is this also something that is not sold by Repair?
[Was there anything that disappointed you?
None in particular. As a precaution, it is recommended to apply Thread compound before installation to prevent galling. Especially in the case of stainless exhaust pipe, it is better to apply it because it is easy to bite.
View detail
Great product especially considering the price. I had it welded on a Takegawa Bomber exhaust for HONDA MSX / GROM and it fits fine on the 42mm part of the exhaust. It will work on smaller and slightly bigger diameter pipes as well. Can be used to fit most
Great product especially considering the price. I had it welded on a Takegawa Bomber exhaust for HONDA MSX / GROM and it fits fine on the 42mm part of the exhaust. It will work on smaller and slightly bigger diameter pipes as well. Can be used to fit most wide band O2 sensors. Thanks to it be being very slightly longer than most bungs it will not have the O2 sensor too much in the exhaust flow, just what's needed to get a correct reading, something to consider when installing such part on a smaller motorcycle / exhaust. View detail
[Webike Monitor] It purchased as a reserve Parts of an air/fuel ratio system in use. It can be used feeling easy for a Mukawa pure Parts.
[Webike Monitor] It purchased as a reserve Parts of an air/fuel ratio system in use. It can be used feeling easy for a Mukawa pure Parts. View detail
It was attached less than 3000 yen by motorcycle store. Since the numerical value used as the measure of the setting comes out, I recommend for who bore up. There was a big difference in outside air temperature.
It was attached less than 3000 yen by motorcycle store. Since the numerical value used as the measure of the setting comes out, I recommend for who bore up. There was a big difference in outside air temperature. View detail
Although it thought that the pure boss for O2 sensors would not stick and would post-install in the muffler purchased at the auction although not attached yet, since there was nothing rather, immediately after searching here, with the M18.1.5 pitch nut, i
Although it thought that the pure boss for O2 sensors would not stick and would post-install in the muffler purchased at the auction although not attached yet, since there was nothing rather, immediately after searching here, with the M18.1.5 pitch nut, it was by marketing.
Although another Mr. Manufacturer's thing was also looked for, it was an about 3 times [ of the elegance here ] price.
According to the form of a pipe, it was cut with the curve, and shone, and since the price was also cheap, it is large-satisfied.
View detail