【SP Takegawa】O2 Sensor Boss M18x10 P1.5 Review
It was attached less than 3000 yen by motorcycle store. Since the numerical value used as the measure of the setting comes out, I recommend for who bore up. There was a big difference in outside air temperature.
It was attached less than 3000 yen by motorcycle store. Since the numerical value used as the measure of the setting comes out, I recommend for who bore up. There was a big difference in outside air temperature.
Responses
Other reviews
Great product especially considering the price. I had it welded on a Takegawa Bomber exhaust for HONDA MSX / GROM and it fits fine on the 42mm part of the exhaust. It will work on smaller and slightly bigger diameter pipes as well. Can be used to fit most
Great product especially considering the price. I had it welded on a Takegawa Bomber exhaust for HONDA MSX / GROM and it fits fine on the 42mm part of the exhaust. It will work on smaller and slightly bigger diameter pipes as well. Can be used to fit most wide band O2 sensors. Thanks to it be being very slightly longer than most bungs it will not have the O2 sensor too much in the exhaust flow, just what's needed to get a correct reading, something to consider when installing such part on a smaller motorcycle / exhaust. View detail
[Webike Monitor] It purchased as a reserve Parts of an air/fuel ratio system in use. It can be used feeling easy for a Mukawa pure Parts.
[Webike Monitor] It purchased as a reserve Parts of an air/fuel ratio system in use. It can be used feeling easy for a Mukawa pure Parts. View detail
Although it thought that the pure boss for O2 sensors would not stick and would post-install in the muffler purchased at the auction although not attached yet, since there was nothing rather, immediately after searching here, with the M18.1.5 pitch nut, i
Although it thought that the pure boss for O2 sensors would not stick and would post-install in the muffler purchased at the auction although not attached yet, since there was nothing rather, immediately after searching here, with the M18.1.5 pitch nut, it was by marketing.
Although another Mr. Manufacturer's thing was also looked for, it was an about 3 times [ of the elegance here ] price.
According to the form of a pipe, it was cut with the curve, and shone, and since the price was also cheap, it is large-satisfied.
View detail