Reviews
Replaced 3 times in 5 years
Cycle to break was 2 years last time, 2 years last time, 6 months this time.
This time, we also have a spare Quantity:2pc. Buy Set
Rear Brake Switch defective at vehicle inspection.
Lousy thing to realize when it is pointed out to you.
Durability depends on Rose.
indescribable (esp. indescribably beautiful)
I thought it would be better than the less than 2000 Chinese
I keep using it.
I need to check it often.
You're wasting your day.
View detail
Fits: YAMAHA Apprio, YAMAHA Super JOGZR, YAMAHA BWS100, YAMAHA JOG90, YAMAHA Axis 90, YAMAHA Grand Axis
BrakeStop switch
Switching according to the mount is suitable, it is extremely difficult to disassemble, it is made as a one-off. The connection wires had to be redone. In general, the option is working, but with drawbacks. -------------------------------------------------- -------- It is suitable to switch on the mount, it is extremely difficult to disassemble, it is made as a one-time. In general, the option is working, but with drawbacks. View detail
We look forward to durability!
By attaching Rear Sets outside the company to the new CBR 250 RR, OEM's Brake switch became unusable and changed to hydraulic type. Hydraulic Switch expects durability because there are many Manufacturers that suffer from problems quickly. View detail
Wiring polarity?
In this time, with the introduction of the Back step, along with the Rear master cylinder exchange, it was necessary to exchange the TailLight switch from Mechanical to the hydraulic type, and purchased this product.
I think that making is good. However, the product of this hand has no good memory of durability. I will look at the progress from now.
When installing, Quantity of this product : Both 2 pc Cable are Red, and manuals are also not mentioned about polarity. If there is no polarity, I would like you to list it in the manual.
After all, there is only Cut & TRY.
View detail
I purchased this product when I was mounting rearsets to my GSX-R1000 K2. Pressure switches often have problems with durability so I chose one from Active, a company that I rely on. 2 pieces electro taps and 2 pieces washers are included in the se
I purchased this product when I was mounting rearsets to my GSX-R1000 K2.
Pressure switches often have problems with durability so I chose one from Active, a company that I rely on.
2 pieces electro taps and 2 pieces washers are included in the set.
I reused the banjo bolt of the rear brake master cylinder.
I was worried that the rear suspension might touch the reservoir tank but there was no problem at all.
The cord is rather long but seemed undurable so I covered it with with heat shrink tube.
I also reinforced the cord extending section with hot bond because it looked unsteady.
There's no problem with the product.
I'm looking forward to the durability.
It would be better if it were more inexpensive.
View detail