Reviews
For diversion to other vehicles
I bought this to use a Power ampA that was sitting in storage.
Power amp seems to be fine without it.
Since we are using high power Coil by Mr. Uotani, we are using the Quantity:I would like to try to operate with Set!
Installation requires a little bit of knowledge, so it would be a relief if you can do general maintenance in addition to the instruction manual.
I don't think we can RECOMMEND that people who don't know better or who don't think they have the skills to purchase the product.
View detail
For strengthening the electrical system of out-of-print cars
[How is it used?
AS Uotani was installed to strengthen the electrical system of YAMAHA XJR400R.
We had the impression that the electrical system was weak due to the fact that the Motorcycle was 15 years old.
As AS Uotani's Manufacturer, we recommend the use of NGK Iridium Plug and Power cable together, so we recommend the use of NGK Iridium Plug and Power cable together.
We decided to install NGK Iridium Plug and Power cable in addition to AS Uotani.
Was the one you received as per Image?
The 6V MONKEY/GORILLA Main Harness side was surprisingly long.
Was the installation difficult?
I think the installation is quite difficult. It would be tough for those who have never tinkered with electrical systems before.
I have to modify the OEMCase to fit the XJR400R because the OEM installation position is smaller than the OEM position and the coils are larger than the OEM. So I decided to modify the OEMCase.
For detailed installation, please see the video.
How was your experience with it?
Power has increased dramatically, partly due to the use of NGK Iridium Plug and Power cable together.
In particular, I have the impression that Torque has increased and the capacity to pull from 1st gear has increased. Perhaps because of the increase in relative power, I feel that I have fewer opportunities to use 6th gear on public roads.
[Included Parts:were they on?
Instruction Manual、Sticker、Harness、IGCoil×2、AmplifiersType A
[Was there anything that disappointed you?
No special requirements.
View detail
I think it is effective in its own way.
Injectionfor Vehicle, but I was able to install it on a 1993 KLX250SR without any problems.
Some people have commented that the length of the plug cord was not long enough for the D Tracker Carburetor, but this was not the case and I was able to install it.
6V MONKEY/GORILLA Main Harness connection, but since Carburetor cars have Bullet Type Terminal, it is necessary to cut the attached Connector of Harness and replace it with Bullet Type Terminal.
The bracket attached to the frame also has a rubber sheet on the reverse side, so it can be attached without damaging the frame.
Coil can be seen through the gap in the Radiator Shroud, which is cool.
As for the effect, when I open the Axel on an uphill, I feel more powerful than before, but I guess it depends on the person.
View detail
good service from webike
fast respond and nice item-recommended for those who planning to improve the performance-ignation systemAbout quality and texture View detail
To repair a ZrX1100 malfunction.
I bought a 1997 ZrX1100 a few months ago and Restore.
Purchased to refresh the electrical system as the Engine is sometimes unable to blow.
We first inspected the OEM Igniter.
Igniter failure is confirmed because an abnormality was found in the value of the part leading to IGCoil.
It seems to me that if the back of the Large body Igniter is in the state shown in the image, it is most likely broken.
Installation took about 2 hours with a lot of jiggling.
Once the location of the Body and the method of fixing it are determined, the rest is easy.
I then unplugged the Plug and looked at the state of Spark before Engine start.
Obviously, the thickness of the sparks is different.
I was glad I bought it from Utani before I let it run.
Engine start
Obviously, you've got a good hang on.
Exhaust system exhaust pressure is also increased.
Running
Low speed Torque is completely different than before.
I'd like to adjust the Uotani REV and MAPSwitch to match the more powerful carburetor in the future.
View detail
I didn't realize you could also buy ShortParts.
Items is essential when using Mr. Wotani and changing the code!
We are proud to be a domestic manufacturer that sells such short parts.
View detail
Could have done without the cord.
Corded. In stock. I was in a hurry and didn't use the code at all, Performance What about the
I don't think Mr. Wotani wrote anything special about the performance of the codes he sells on his homepage.
Does the code alone change performance in any particular way? I'm puzzled.
Ignition coil installed on YAMAHA's Initial Model BirdCity125.
Normal cord ILLUSTRATOR code was left in place with Plug since it was not possible to install in the NORMAL position.
I'll post a picture, but please don't copy it as it's at your own risk.
Plug cord replacement is a hot wire 90-degrees type that can be used for AXIS 90 and so on.
This time, the plug is NGK's Standard Type.
View detail
SmallSize Sticker
It was the same etc. as the Size that is pasted on the SPIIIgnition coil.
Buy SmallSize if you want to stick it on the opposite side when installing Ignition coil or if it is upside down.
View detail
AS Uotani Plug cordco NECTO
Purchased with AS Uotani Coil cord extension View detail
Stock as a backup
Even if you need to make a quick trouble, you can rest assured that there is a dedicated product for you. That's why I'm using Stock. View detail
Fits: SUZUKI GS400E, SUZUKI GS400E
This is awesome.
I had no complaints with the Dyna S, but since I bought it, I decided to install the Uotani.
Comparison with FXDC DYNA SUPER GLIDE CUSTOM below Settings are both 0
Although the kake was originally a single shot, from the beginning the heartbeat was stronger and more stable.
I feel that the intake is a little better, but I don't feel that much change since I also smoked with FXDC DYNA SUPER GLIDE CUSTOM.
Idling is more powerful and stable than that of the FXDC DYNA SUPER GLIDE CUSTOM, although the FXDC DYNA SUPER GLIDE CUSTOM was also stable at low rpm.
The acceleration is different; it is definitely faster than FXDC DYNA SUPER GLIDE CUSTOM, as if the Torque has been increased.
I've ridden both Point and FXDC DYNA SUPER GLIDE CUSTOM, and if you can afford it, I thought there was no harm in buying the Uotani.
Now we hope for durability.
View detail
Great Tuned Up For Minibike.
This system could mods your bike differently, much torc, more responsive and your bike sounds better. The crank sound really great for my Honda Monkey 125. View detail
Torque up and improved at medium and low speeds
I finally decided to install the special Quantity by Mr. Utani, which is safe, secure, and easy without worrying about Igniter or Point load depending on Power amp in the long run.:Set.
What you ordered is SPIIQuantity for Z-specific Spec.:Set, I am not very good at electrical systems, unlike mechanical and structural systems.:Set will be easy to connect and install without failure.
First of all, we would like to conclude that, despite the good price, the effectiveness and durability of these parts have already been highly evaluated by many people, and we can say that the easy installation and the fact that we were able to confirm the effectiveness even on a car that looks like a new car is a sure sign of their reputation.
Three instruction manuals are included:PowerCoil/AmplifiersKit, Check Canceller, and Kit Installation Instructions.
I was not very good at this, so I checked the contents carefully, and I installed the body after doing the assembly and parts that could be prepared in advance.
The plug cap is attached to the NGK cap, which is a little hard because of its waterproof function, so I used silicon grease on the surface of the cord to slide it on. The installation of the plug cap was done on a large size, and it was installed by twisting the plug cap all the way to the back.
In case I fail, the cord is long enough that I can afford to cut it off and try again, so I think it will be easier on my mind.
As for the Others, I was able to easily connect and install the Coil AmplifiersKit by simply installing it as described in the manual.
In addition, I put it together by trial and error while watching the load of Wiring so that it would not get in the way during maintenance in the future due to the delicate feeling of where Wiring and terminals go in the connection of Can Sera-.
Before installing the side covers and frame covers that were removed at the time of installation, startup checks are made and each cover is installed to complete the work.
After the work, the engine warms up, the idling is stabilized, and the torque at low and mid speeds has been increased!
Furthermore, the Axel's adhesion at mid-range speeds is a little better, and the rear tires feel as if they are kicking the ground firmly.
The parts are still close to the condition of a new car, and the work has been updated with new parts, so I thought it might be difficult to see the effect of the work.
There is no particular problem, but I dare say that Z hides CoilKit with Covers, Color:Gray's Plug cord is plain and has no Custom feel.
Sticker was enclosed...maybe I can keep it plain as is? I am thinking about it.
I would like to explore Z optimization in the future by adjusting various Plugs and Gaps.
View detail
repapering
The color had faded to a Pink color, so I had to replace it with a new Sticker. The selling price was not too expensive. View detail
This is not the only thing I changed, so ….
Installed on 12VMONKEY.
I purchased it this time to improve a mysterious starting problem.
Replaced by Uotani→Uotani.
So the effect of the utani itself is unknown.
The first generation was also at the same time as the Head replacement, so I didn't know much about it.
Well, I like the way it looks, so it's ok.
However, it is also compatible with Tachometer and CDI, and my
In this case, the Tachometer malfunction did not stop even if a resistor was inserted.
Change to CDI for a certain Chinese Engine and say it settles down.
It was a strange event.
The compatibility of each item can only be determined after installation.
You should buy with your head in the sand.
View detail
As an OEM alternative
[How is it used?
I really wanted to ride the very Large popular Motorcycle that was sold when I was a teenager, so I purchased this product in the process of getting a vehicle that fit my budget at the time and restoring it with hanghang.
Was the one you received as per Image?
Since the product was familiar to us because it had been displayed and sold at Motorcycle accessory stores for a while (well, it is an ignition system product), the product was just like Image.
Was the installation difficult?
There are some tedious parts, but the level of difficulty is low.
The products purchased this time are Universal Product. Therefore, it is only necessary to perform the appropriate installation for each vehicle based on the Installation Instruction Manual.
How was your experience with it?
The vehicle in which this product was installed this time has been manufactured for about 36 years and OEM parts are no longer available, so this product was installed as a replacement.
To be even more frank, the vehicle was originally acquired in an immobile state, and every part of it, not just the ignition system, was in shambles, so I don't know how NORMAL it would have been. "This product is so much better now that I have it installed!" I cannot do a targeted Review.
I have been riding around the area after the Restore was completed and the startup is very good.
Power & Torque, Carburetor Body, Jets, and Chamber have been replaced at almost the same time. Uotani SP II I'm not sure if it is because of the "aftermarket parts", the other aftermarket parts I replaced, or the effect of the Total.
Personally It's not that his condition is getting any worse." I am glad that I purchased this product.
[Included Parts:were they on?
All items shown in Webike's product images.
[Was there anything that disappointed you?
So far, none at all.
The product being purchased this time is Universal Product. Therefore, there may be some missing parts (e.g., short plug cord, etc.) depending on the vehicle in which it is installed.
Other items that would be helpful
Point and hang of installation
I don't have excellent knowledge of electrical systems. Stick to the basics." Installed.
Unless you have a variety of application techniques, it is a good idea to stick to the basics.
[Availability and clarity of the Instruction Manual
Because it is a Universal Product Basic." Installation Instruction Manual is included.
The instructions are clearly written, so if you are not confident, read them carefully and get to work. My friend with extensive knowledge of electrical systems." Or "PRO" Let's leave it to the
[Notes]
Although I think it is Large sturdy, it is safer to turn off the Main switch and disconnect the Battery terminal when working on it.
[ITEMS TO BUY TOGETHER
Since you are installing a new Plug cap and ignition Plug, you should use a new Plug cap instead of a used Plug or a reused Plug cap.
[Opinions and requests to Manufacturer
I believe that there will continue to be demand for restoring old vehicles and powering up ignition systems, so I hope that you will continue to sell these products for many years to come.
View detail
warty frog shell (Bursa bufonia dunkeri) SPII
Purchased to strengthen the ignition.
Idling stability etc. were
View detail
อุปกรณ์สวยงามใช้งานได้อย่างดีเยี่ยมจ่ายไฟได้อย่างดี View detail
Startability and Idling has been stabilized!
I replaced it with IGCoilRefresh on an older vehicle (TT250R) and the results exceeded my expectations.
I have installed the full powerKit and Ignition coil from Uotani on many different types of cars, but this was the most effective!
In NORMAL, pull the Chalk. I had been repeating the same cycle and warming up the car for about the third time, and it seemed to stabilize somehow, but after I switched to the Utani, it really started to work. Cultotototot." and Cell1 from cold time without even pulling Chalk was a surprise.
I was impressed because there is almost no difference in temperature since we tried it before and after the exchange on the same day.
I changed the plug and plug cord together, so there is a possibility that the degradation of NORMAL was severe, but I am Large satisfied with this result!
These parts reminded us that when maintaining or restoring an old motorcycle, it is essential to refresh the ignition system.
*I haven't had time to ride it, but I'm wondering if it's Torque up enough that it doesn't feel like an amateur? I hope so.
View detail
Stable Utani Coil
This is the 4th vehicle for us to install this system, including MONKEY, Wolf200, RG250Gamma, and now 500SS (H1F).
I don't expect dramatic changes, but it is a reliable Brand and I will continue to use it.
View detail