Reviews
Instead of Tie Wrap
I used to check the amount of stroke by wrapping Tie Wrap around the Inner Tube, but I decided to use this product. It is possible to install without removing the Fork, but it took some time to attach the Spring which holds the Body in place. It is a bit pricey, but I recommend it because it looks good, parenthesis is good, and it is functional. View detail
It's a good product but I think it's a bit expensive….
[How is it used?
ZX-6R Φ41. Tie Wrap would be fine but it looks like that.
Was the installation difficult?
Installation is easy, but requires a bit of hang. If you install it by expanding the ring, it will be irreversibly deformed.
The spring is designed as a screw, so it is pulled with a slight twist.
How was your experience with it?
This Ideas product looks good and can be installed without disassembling the front fork, but it is too expensive.
If you are not picky, Tie Wrap is sufficient.
View detail
Tie Wrap is tacky.
I think Stroke sensor tends to be done with Tie Wrap, but it doesn't work well and is tacky.
This Stroke sensor is used for Material:It is Plastic, so it moves well and is easy to install.
It is not a Cool translation, but it eliminates the tackiness.
View detail
Cool!
I had the O-ring installed at the time of FFork OH at a certain place and had no problem at all with it as it was, but I bought it because Parenthesis is good.
The instruction manual was so thin that I couldn't read it at all, but the installation was very easy. At first I tried to connect them after inserting them into the groove, but I had to pull a lot to do so, which seemed a bit unreasonable.
I'm happy with Large, but when I put FFender together, you have to look through it to see it at all.
View detail
For Sports driving
I bought it partly for self-satisfaction and partly to see how much the front suspension moved when running Sports and Winding. 。
Installation is simple, but I thought a little ingenuity was needed.
For CBR600RR, MODEL that uses Inverted Front Fork (PC37 late or PC40) for a 41mm one.
View detail
The vibe is Racemascene!
What was the deciding factor in your decision to purchase, install, and how do you feel about using it?
Recently, I was wondering what I should install next on my 6R. When I was searching the Net, I found "Nex Performance:Stroke sensor" is a necessity for suspension setting, but it was not possible to install it without overhaul of the front fork. However, Nex Performance:Stroke sensor is designed for easy installation. However, care must be taken not to force open the sensor ring or pull too hard on the spring, which may cause the spring to stretch. In this case, it took about 5 minutes to complete the work, although it required some hang time to screw the spring in. I am looking forward to checking the 6RFront forkStroke condition after driving on the street, winding, and at high speeds. In case you are wondering, the 2021 ZX-6R was 41Φ.
View detail
Race ish casually
This ring measures the amount of stroke of the front fork.
So far I have been wrapping Tie Wrap around the Inner Tube.
Tie Wrap would have been perfectly fine, but we decided that a dedicated product would look better anyway.
The white ring has a cutout that opens into an inner tube.
A little hang is required to wrap the spring around the ring.
Be careful not to wrap the Spring too tightly or it will stretch.
It looks good and is kind of race ish, which is good.
This is also recommended for those who prefer these kinds of parts that give a casual race ish feeling.
View detail
Parenthesis is good but the price is a bit expensive.
Set the Stroke amount of Front fork to
Easy to understand to check.
You can install the Spring and Sensor ring separately.
Install the sensor ring by spreading it up and down.
Quantity:Pair (for Left and Right) Scauperoon and down to one machine after installation when spread out to
It falls off.
In that case, remove it and round the Ring a little to make the inner diameter
I'll make it small.
Be careful not to overdo it or it may break.
The tip of the spring is a convex and concave screw type.
Picking up the endsQuantity:Pair (for Left and Right) Pull it as far as you can reach the
If you pull too hard, it will stretch and the Band will not work.
Note that this will not work.
Twist slightly counterclockwise when pulling, and at the point where the bumps meet.
If you turn it clockwise, it will match and form a circle.
Finally, we put Spring into the groove of Sensor.
Quantity:I feel that 1pc. is rather expensive.
I wish it was a little cheaper.
View detail
It's expensive.
It may be necessary for the setting for the serious people.
For me, as an amateur, it's a toy that makes me smile when I see the amount of Stroke after driving on mountain roads.
It's good for a little self-indulgence.
View detail
It's definitely better than Tie Wrap!
The front fork on a motorcycle is always moving with the road, isn't it?
But have you ever wondered how much it's working?
I often see them installed on Motorcycles that run on Circuit Stroke sensor
Some of the modern motorcycles are equipped with an electronic stroke sensor But the Large Motorcycles are not included Tie Wraps are often used for Displacement Volume motorcycles and the like Sometimes I put it on and substitute it
I'm one of them...Tie Wrap is enough! And I've used it until now
However, if you put too much pressure on it and stop it, it can cause damage to the inner tube when you chew on debris or something If you tighten it gently, it won't work
I think I could do this one because it can be done briefly, but when I was rummaging through the We-Big, I found the Stroke I found a thing called sensor
Hmm, the price in its own way
And it's only 1pc. so I guess I could use Tie Wrap
But I bought it for the long-term Inner Tube Damage and for the sake of looking good! It was
I installed it on YAMAHA's YZF-R25
It's GOOD because it looks cooler now
View detail
As a matter of fact, it's good
If you know the amount of Pre-road and Bottom, the rest is not so necessary, so you can use In-Hemp Palmick is enough But the accuracy and slippage are very safe and gentle to Fork I felt the price is too high View detail
Can I use it for Front suspension adjustment?
I purchased thought to use for adjustment of Front suspension in Circuit driving.
Easy to install, just plug in White resin and stop with Spring. I think that it will end in less than 1 minute.
Although it can be used for pre-road adjustment of Front suspension, since only the place where you made the most Bottom is known, if you make a full Bottom even while you are traveling, it will be stopped at the same position each time. It is almost meaningless to make the Front suspension softer than a certain amount.
As an appearance effect, a Race ish atmosphere appears.
It is not necessarily indispensable, but I think Motorcycle can be SS.
View detail
Stroke quantity is visible so it is easy to manage
I have not done Suspension setting until now, but after installing this product, I can grasp how far I am using the amount of Stroke, Front - It became possible to adjust to the comfortable ride including Rear and it changed to what it thinks is really the same Motorcycle. Once purchased it will not be replaced so I think Cost performance is good. View detail
I had been using a insulation locking band instead of a stroke sensor, but decided to try this part because it said that I could install it without disassembling the front fork.The tip of the spring is threaded and you can connect it by making it
I had been using a insulation locking band instead of a stroke sensor, but decided to try this part because it said that I could install it without disassembling the front fork.
The tip of the spring is threaded and you can connect it by making it into a circle. Still the spring force is a bit strong, and you might find it hard to make it into a circle by threading its tip.
Once you install it, you will feel like "That's all?"
It's just a product to measure the front stroke amount, nothing special. But it's a necessary part for the setting operation.
However, I think its price makes one hold back from buying it.
I think it should have a price like 1500 yen or so, but maybe it's priced this way for there are almost no other competitive parts in the market. For this reason, I posted 4 stars.
View detail
It was used also by all the vehicles (ZRX1200 ZRX1200 DAEG).If you have got to know and managed the amount of Strokes, it is convenient in it being various at the time of a Setting.It is worries whether by a Spring, although it is fixation, it is separate
It was used also by all the vehicles (ZRX1200 ZRX1200 DAEG).If you have got to know and managed the amount of Strokes, it is convenient in it being various at the time of a Setting.It is worries whether by a Spring, although it is fixation, it is separated and lost for a while ... View detail
[ -- the Webike Monitor ] -- it is very better for appearance than being attached simply and aiming at a Stroke by a Cable tie too! Even if it does not remove a Fender, a white Teflon is inserted in, a little Spring is pulled, and it is ラクラク wearing
[ -- the Webike Monitor ]
-- it is very better for appearance than being attached simply and aiming at a Stroke by a Cable tie too! Even if it does not remove a Fender, a white Teflon is inserted in, a little Spring is pulled, and it is ラクラク wearing in a screwed type!
View detail
Attachment is easy. Since the raw material is unknown, I want you to write. I feel that it is expensive.
Attachment is easy.
Since the raw material is unknown, I want you to write.
I feel that it is expensive.
View detail
[a good place] - it attaching, when a front fork is usually decomposed, but. Since the amount of strokes is known at a glance by the thing which can remove at any time since the tip of the spring which stops - ring which can be attached as it is since
[a good place] - it attaching, when a front fork is usually decomposed, but.
Since the amount of strokes is known at a glance by the thing which can remove at any time since the tip of the spring which stops - ring which can be attached as it is since this stroke sensor has a break is a screw type and to - Attach, there are several kinds of effective and sizes also as convenience and dress-up items up,
I think that 2500 yen is high to Faulk of various thickness by two points, the ring made from Buu correspondence (there is also size which is not) a [place] and plastic, and the spring which stops it.
Have applied money to which portion. -- A binding band is also enough if you would like to only know the amount of - strokes.
However, although attachment of them is possible, without decomposing a [general comment] and F Faulk although appearance and removal are thats, and they are goods with an effect high also as dress-up parts moreover, they are sorry about a price.
However, those who are adjusting Sas are not bad to attach, either.
View detail
OHLINS -- by appearance [ tic ], I think that it is better than a free black rubber. At the time of wearing, although I suffered troubles just for a moment, I stuck somehow. I think that it is good rather than separating simply, but they are four
OHLINS -- by appearance [ tic ], I think that it is better than a free black rubber.
At the time of wearing, although I suffered troubles just for a moment, I stuck somehow.
I think that it is good rather than separating simply, but they are four stars in such a sense.
View detail