【NEX Performance】Stroke sensor Review
Instead of Tie Wrap
I used to check the amount of stroke by wrapping Tie Wrap around the Inner Tube, but I decided to use this product. It is possible to install without removing the Fork, but it took some time to attach the Spring which holds the Body in place. It is a bit pricey, but I recommend it because it looks good, parenthesis is good, and it is functional.
Responses
Other reviews
It's a good product but I think it's a bit expensive….
[How is it used?
ZX-6R Φ41. Tie Wrap would be fine but it looks like that.
Was the installation difficult?
Installation is easy, but requires a bit of hang. If you install it by expanding the ring, it will be irreversibly deformed.
The spring is designed as a screw, so it is pulled with a slight twist.
How was your experience with it?
This Ideas product looks good and can be installed without disassembling the front fork, but it is too expensive.
If you are not picky, Tie Wrap is sufficient.
View detail
Tie Wrap is tacky.
I think Stroke sensor tends to be done with Tie Wrap, but it doesn't work well and is tacky.
This Stroke sensor is used for Material:It is Plastic, so it moves well and is easy to install.
It is not a Cool translation, but it eliminates the tackiness.
View detail
Cool!
I had the O-ring installed at the time of FFork OH at a certain place and had no problem at all with it as it was, but I bought it because Parenthesis is good.
The instruction manual was so thin that I couldn't read it at all, but the installation was very easy. At first I tried to connect them after inserting them into the groove, but I had to pull a lot to do so, which seemed a bit unreasonable.
I'm happy with Large, but when I put FFender together, you have to look through it to see it at all.
View detail
For Sports driving
I bought it partly for self-satisfaction and partly to see how much the front suspension moved when running Sports and Winding. 。
Installation is simple, but I thought a little ingenuity was needed.
For CBR600RR, MODEL that uses Inverted Front Fork (PC37 late or PC40) for a 41mm one.
View detail
The vibe is Racemascene!
What was the deciding factor in your decision to purchase, install, and how do you feel about using it?
Recently, I was wondering what I should install next on my 6R. When I was searching the Net, I found "Nex Performance:Stroke sensor" is a necessity for suspension setting, but it was not possible to install it without overhaul of the front fork. However, Nex Performance:Stroke sensor is designed for easy installation. However, care must be taken not to force open the sensor ring or pull too hard on the spring, which may cause the spring to stretch. In this case, it took about 5 minutes to complete the work, although it required some hang time to screw the spring in. I am looking forward to checking the 6RFront forkStroke condition after driving on the street, winding, and at high speeds. In case you are wondering, the 2021 ZX-6R was 41Φ.
View detail