Reviews
Fits: YAMAHA FORCE 155, YAMAHA SMAX, YAMAHA Majesty S
Don't buy it.
Bought this to replace a worn out clutch. 39mm nut can be replaced even if you can't loosen it with the integrated Driven! And it's cheap! It was a mistake to choose it with such an idea.
When I checked that it was assembled properly and turned the rear tire a little, I heard a strange noise like "PelePera". After turning it a little and reassembling, the noise did not occur, but it sounded depending on the phase of the driven.
And when I actually used it, I was impressed that the clutch connected at about 3000 rpm immediately after assembly and the sharpness of starting was restored, but after only 40 km of driving, an abnormality occurred. However, after only 40 km of driving, the start became sluggish to the same extent as the worn-out condition. (RPM at this time:6000 rpm)
I had no choice but to keep driving the car, and the connection got better again, which is not so clear, but when I drove the car more, I heard a strange noise like a skirring sound at the start. When this happens, no matter how carefully I try to connect the clutch, the clutch slips and the starting becomes incredibly slow. After riding for a while, the sound was gone, but the car started back to the same nippy start as before the replacement. I had not even driven 1000 km so far.
At the end of the day, the car hit the GuardRail foundation during a sudden stop while controlling a slow start and was almost scrapped. Although my driving was the main cause, I cannot deny that this Part was a remote cause.
It should be replaced with OEMClutch with the proper tools.
View detail
Fits: HONDA Superdio, HONDA Superdio, HONDA Dio (2 Cycles), HONDA Dio (2 Cycles)
It sucks
How about aiming for the highest speed? So I bought it because it was.
But when I installed it, because the highest speed obviously fell, when I confirmed it in the homepage of KN Planning, it was said that it was possible to make more low GEAR.
What is the highest speed target? Bullshit.
View detail
Fits: HONDA PCX125, HONDA PCX125, HONDA PCX125, HONDA PCX150, HONDA PCX150, HONDA PCX150, HONDA PCX125
It was a waste of Gold
I should have bought the OEM Product properly
Exchange with the same KN project Belt
I had to put up with it for a thousand miles
Top speed drops 20 km/h Fuel economy drops by 20%
So you're going to get Torque then? Of course, it doesn't answer
This is exactly what it means to be a cheapskate
I've learned a lot
View detail
Fits: HONDA PCX125, HONDA PCX125, HONDA PCX125, HONDA PCX150, HONDA PCX150, HONDA PCX150, HONDA PCX125
performance degradation
The result of being stingy and cheap
The top speed is now 90KM and Limiter is now taken
On top of that, I lost about 10?liters of gas mileage
View detail