Reviews
I feel this is enough for Sunday mechanic
[How is it used?
I purchased this product to remove and install the snap ring for the rear master cylinder O/H of my YAMAHA/XJR400R. I chose KITACO because they are relatively inexpensive among various manufacturers.
Was the one you received as per Image?
It was exactly as shown in the Image. It is larger than I expected, so it has some presence in the tool box.
It may be surprisingly troublesome to store the Head section.
How was your experience with it?
I had no problems using it. The only thing I have to say is that the tip seems to be quite fragile, so if you handle it poorly, you may end up chasing it. Also, the Instruction Manual is on the back of the container, so it is hard to dispose of it...
[Points to note]
The tip is a delicate part and can be easily broken if handled roughly, so care should be taken.
How did it compare to other products?
Are the cheap ones still from the same supplier? I looked around and found the same thing.
But even if you buy the expensive ones, they are Sunday mechanic, so they are used less often.
Therefore, we think it is a good idea to use these cheap products with crushing vigor.
View detail
Poor.
I bought it because I thought it was cheap and good that the tip could be replaced.
The downside of the tip replacement is that it often hits too many areas and cannot reach tight spots.
The C-ring is so hard that the tip is useless because it is wobbly.
At any rate, I can't RECOMMENDATION because there are so many irritating POINTS.
We managed to finish the work, but it was a Level we never wanted to use again.
Tools are Large stamps.
View detail
cheap
It works fine
It's not much of a turnout, but it can be used for 3Pattern and the price is very reasonable.
Too easy.
I tried to get them in Knipec Fat.
I decided to go with this one because it's more expensive.
I'm satisfied
Recommended items
View detail