Reviews
I don't like the Round Type Mirror on the 2024GROM.
I purchased this product because I could not get used to the design of GROM's Round Type Mirror, which was apparently a reuse of the for MONKEY mirror.
I chose "Made by HURRICANE" because I thought it was better than the inferior "Large Land" products. The installation is not so difficult, but there is no instruction manual, and the package is not printed, so inexperienced users may have some trouble!
The design is good, but the Mirror angle has a small vertical adjustment range and requires fine adjustment at the Lever mounting point.
Somewhat disappointing in terms of product
View detail
Inexpensive and practical
Inexpensive and practical.
Necessary and sufficient
View detail
Inexpensive and practical
Inexpensive and practical.
Necessary and sufficient
View detail
Inexpensive and practical
Inexpensive and practical.
Necessary and sufficient
View detail
Conti II type can be NORMAL.
The OEMHandlebar is so large that if it is replaced with a narrower one, the OEM will have a little extra space.
However, it could be left as OEM, but it interfered with the RadiatorRight Side surface.
It is a product that is better to have than not to have.
View detail
Bar handle has
I used to use 10cm Long on my HURRICANE Pipe Handlebar Kit, but it was too long, so I decided to use 5cm.
Clearance is just fine.
View detail
What about shipping?
It's been over a year, have you shipped the product yet? View detail
Replace OEMHandlebar
Separate Handlebars are too aggressive; Swallow handle is too short
Therefore, it becomes Condor Handle.
However, in the reverse position (where the Grip is lower than the Clamp), there is too little Clearance between the bar and the Blinker.
View detail
HURRICANE HURRICANE Cat's Eye Mini Tail Lamp Kit
[How is it used?
The OEM tail lamp was replaced because it was too large.
Was the one you received as per Image?
It was nice and clean as per Image.
Was the installation difficult?
It is not that difficult.
How was your experience with it?
It was nice to see it look shapely.
It is good because I have not seen many people installing them.
[Included Parts:were they on?
There is none
[Was there anything that disappointed you?
The point where the Red light from the Tail lamp illuminates the Number.
Blackish Tape was pasted inside to keep it from illuminating.
View detail
HURRICANE HURRICANE Reflector
The product was as per the Image.
There will be a gap between the Number and the Reflector, so we do not recommend this if you are concerned about this. (It will look like it is gnawing out of the Number.)
View detail
Price suitable
The screw holes were accurate and there are no problems with installation or appearance. View detail
Fits: SUZUKI RV200 VANVAN, SUZUKI GRASS TRACKER, SUZUKI GRASS TRACKER Big Boy
meticulous manufacturing
It was good up to the point of installing the Coupler on the body side of the NORMALIndicator with the Coupler, but the remaining Black color code was installed with Tap for Connection and the Instruction Manual's Sky blue code. The sky-blue code is used to connect to the Quantity:There are 2 pcs and the first connection failed, but I opened the Tap and connected it to the dark sky blue cord and it lit up fine. View detail
(Commuting) BattleMirror
I was concerned about the width of OEMMirror and purchased it. It is not only wide, but also tall, and is built as expected.
Compared to other products, the design is more OEM-like, so I think the balance with the overall body is good.
By the way, this is the second time I bought this because the one I bought before broke.
View detail
Fits: HONDA HORNET250, HONDA APE 50, HONDA APE 50, HONDA APE 100, HONDA VTR250, HONDA VTR250, HONDA NC700S, HONDA FTR223, KAWASAKI ZRX1100II, KAWASAKI ZRX1100, KAWASAKI W800, KAWASAKI W400, KAWASAKI ZEPHYR400, YAMAHA XJR400R, YAMAHA XJR1300, YAMAHA XJR1300, YAMAHA TW225E, YAMAHA TW200E, YAMAHA TW200E, YAMAHA TW200
This is what it looks like when installed on a KTM 2013 DUKE.
This is what a BMConti2-type Handlebar looks like when attached to an Initial ModelDUKE. Finger is about the same height as Limit. View detail
Fits: YAMAHA XJR400R, YAMAHA XJR400, YAMAHA V-MAX 1200, YAMAHA SRV250, YAMAHA SR400, YAMAHA FZR400, SUZUKI GSF1200, KAWASAKI ZR-7/S, HONDA Monkey BAJA, SUZUKI GSF750, YAMAHA XJR400, YAMAHA XJR1300, YAMAHA XJR1200R, YAMAHA XJR1200, YAMAHA SRX600, YAMAHA SRX400, YAMAHA SRX400, YAMAHA FZR250R, YAMAHA FZ400, SUZUKI BANDIT400
HURRICANE triangular table spindle nut
Exquisite workmanship, cheap price, good materials, beautiful colors, very accurate size, easy to install, and fits perfectly in the car View detail
Good position
I came across this product after doing a lot of research on the height and width of the Japanese Vehicle Inspection Correspondence on the CB750rc42.
The width is the same and the height is about 35mm higher than the other two, so I asked the shop that installed it to check if they had done the same thing and since it was compliant, they installed it without refusal.
Extension Harness was also prepared in case, but it was used only for Blinker switchWiring extension.
For this level of uplift, it would have been more cost-effective to just extend the Blinker switchWiring than to purchase Extension Harness.
The position is only 35mm up, but it feels much higher, and the handlebar feels a little tighter in the front, so it is very easy to drive.
It is as easy as if it were a learner's car, but the system is also very windy as it approaches vertical.
I am self-satisfied, but it was a good decision to replace it because it is totally easy to drive and maintain a non-fatiguing position.
View detail
excellent quality
Extremely solid, well made bars. I have fitted inverted for a low clubman style. Works well in combination with the bar end mirors and SSK adjustable levers. View detail
took a chance and it payed off
Snapped the original cable. Ordered the short cable for the standard Z900RS after fitting lower bars. Worked out within 10-15mm of the Z900RS Cafe OEM cable length. Great fit. Fast shipping as always. View detail
Fits: SUZUKI GRASS TRACKER, SUZUKI GRASS TRACKER Big Boy, SUZUKI GRASS TRACKER, SUZUKI GSX400, SUZUKI ST250 E Type, SUZUKI ST250, SUZUKI RV200 VANVAN, KAWASAKI BALIUS2, SUZUKI GSR400, KAWASAKI ZEPHYRX, KAWASAKI ZEPHYR750 RS, KAWASAKI ZEPHYR750, KAWASAKI ZEPHYR1100 RS, KAWASAKI ZEPHYR400, KAWASAKI ZEPHYR1100, KAWASAKI ESTRELLARSCustom, KAWASAKI ZRX400, KAWASAKI ZRX400II, KAWASAKI ZRX1200R, KAWASAKI ZrX1200ZrX1200 DAEG
Used for ST250
Used for ST250.
We were happy to be able to use the Wires as they were.
View detail
It's best.
Transforms into a classic look.
The driving position is very comfortable and stable.
Even if you drive for a long time, it will not put any strain on your body.
Handle replacement can be done quickly if you purchase the Hurricane extension harness together.
This is one of the customizations I am most satisfied with. -------------------------------------------------- -------- Transforms into a classic look. The driving position is very comfortable and stable. Even if you drive for a long time, it will not put any strain on your body. Handle replacement can be done quickly if you purchase the Hurricane extension harness together. This is one of the customizations I am most satisfied with. Powered by Google Translator
View detail