【HURRICANE】Short clutch cable Review
took a chance and it payed off
Snapped the original cable. Ordered the short cable for the standard Z900RS after fitting lower bars. Worked out within 10-15mm of the Z900RS Cafe OEM cable length. Great fit. Fast shipping as always.
Responses
Other reviews
Separate handle by all means!
If Separate handle is selected, the NORMAL clutch wire will be too much.
What kind of harm will be done?
The Clutch is not turned off, but it is turned off, or at worst, it gets tangled in the Wheel and becomes Large.
Shorting is necessary to prevent these problems.
It is -100mm shorter than NORMAL.
good point
When separate handle is used, the clutch is cut smoothly.
XX semi-cra is also easy.
There is also the rigidity of the ○Cable.
The price is also low.
A bad point
Installation is troublesome.
○Peasy to rust if lubrication is neglected.
I need a Cable that matches the length of the Handlebar.
For Separate handle, Normal cable should not be done in the sense of prevention.
View detail
Reliable Manufacturer.
When I replaced the BEETTAPER Handlebar, the NORMAL Clutch Cable sagged.
I bought this one because it looked bad.
Above is the length Exactly to Handlebar.
View detail
It is a must for Continental handle.
When I exchanged the z900rs23 model with the HURRICANE Conti2 type, the Clutch Cable was long and it was a bit of a poor parenthesis because of the Dollar. I removed the cable from the engine side, and then removed the clutch side. I wrapped this product around the OEM Cable with Vinyl Tape and pulled it from the Engine side. I was a little disappointed, but the Cable also passed under the tank without any problem. I had a little trouble installing the cable on the engine side, but I managed to do it. The length is almost the same as OEM. View detail
Nice
I bought and replaced the fat condor handle bar from the hurricane company. It is compatible with genuine clutch cables, but the cable on the clutch case side is stretched out, so it is perfect to purchase and install the above product. It took about an hour when I replaced it by myself. I think it took some time because it's my first time. View detail