Reviews
Fluid is slightly blotchy….
I wanted to make the crossover type of Swage linePRO into an h-shape and shorten the hose length as much as possible, so I purchased this GOODRIDGE 160mm and 310mm hose and a T-shaped 3-way Fitting Adapter.
However, I was so traumatized that I could not remove the air from the OEM Master Cylinder, and I wanted to reduce the air removal work as much as possible, and I was tempted to remove the Caliper and wash it in the washroom. I wanted to reduce the amount of air venting work as much as possible. (It was too expensive and the quantity was too high).:2pc. Set can't be bought either, so only 1 pc. …)
However, due to the fitting, it was not possible to make the "h" shape, which was the original goal, and the 310mm Hose and 3-way Fitting Adapter were not used.
The installation was completed without any difficulty, and after bleeding the air, we went for a test run to confirm that the brake was working properly.
When inspecting the Hose area after the test ride, is the Hose fitting on the underside of the Stoveli wet?
At any rate, I wiped it off that day and checked it about a week later and found that the fitting was still wet, so it might be Overtorque, but I retightened it and left it again.
I gave up because the Fluid still oozed out of the Fitting.
*I think it's usually NG, but it's not like it leaks, it's more like it seeps, so I always inspect it before driving.
At first, I was afraid that it was leaking from Stoveli, but there was no Fluid adhering to the Connector, and Fluid was adhering from the Fitting of the Hose connected to the Stoveli, and it seemed to be slightly seeping from the Fitting on the Caliper side, and after driving, the Dust seemed to be adhering as shown in the image. After driving, it seems that dust is adhered as shown in the image.
The Swage line installed on the upper side of the Stove top is not seeping, so I would like to change it to theirs, but the minimum hose length is 20cm even with Easy order, so I would like to leave it as it is for a while, and if the symptoms worsen, I would like to take measures.
By the way, I used this GOODRIDGE Hose on another vehicle and it never bled, so I'm sorry to hear you pulled a HaGap.
View detail
If the wiring outlet is bent, it will cause problems.
I think it's better to put it on the pressure sensor.
I think it's good for the protection and appearance of the wiring, but it's expensive…
View detail
Bolt-on Kit by vehicle type ???
Product creation etc.. I think that it is solid..
However, despite singing as a vehicle type Bolt - on Kit,
I will not do it properly as it is.
I do not know whether the design of Kit is sweet or a strategy for buying additional parts,
If you come to a vehicle inspection in this Kit only condition, I (Ex inspector) If it is not conformity certificate.
Is Motorcycle supplies such a thing natural?
It happens to be only for our model.
I think the product itself is not bad.
View detail
Not good
Even though it is different depending on the model, Hose is a little short, like NORMAL
It is slightly hard to walk around, so I got an angle
I bought Banjo again and installed it.
Usage impression is without complaint.
View detail
Things are good - - -
Although the quality as a thing was good, closing Banjo Nut was 11 mm and it was hard to use and it was KTC's Spanner
I can not join, is Black color a little thick?
View detail