Reviews
Fits: Others Universal
It was a little too flashy.
I bought this for Number protection and dress-up.
I imagined that the License PlateBody would fit in the body, but it was not quite large enough, so it stuck out. I had to put the attached cushion on it because it floated.
The frame itself is a bit Large, so in the case of Gold, it was an unfortunate point that it would stand out too much.
I think it is an Exactly product for those who like to be flashy.
View detail
peeling off
I purchased this product in the hope that it could be used to remove Packing, Rubber, and Sealants.
The tip of the blade is a size and both tips are taper shaped, so it seems to be good for use.
View detail
Fits: SUZUKI GS1200SS, SUZUKI GSF1200S, SUZUKI GSF1200ST, SUZUKI GSF1200V, SUZUKI GSF1200SV, SUZUKI GSF1200SAV, SUZUKI GSF750, SUZUKI GSR250, SUZUKI GSR250F, SUZUKI GSR250S, SUZUKI GSR400, SUZUKI GSR400, SUZUKI GSR400, SUZUKI GSR750, SUZUKI GSX-8S, SUZUKI GSX-R1000, SUZUKI GSX-R1000, SUZUKI GSX-R1000, SUZUKI GSX-R1000, SUZUKI GSX-R1000
usually
It is an ordinary Oil Element.
I cannot tell the difference from other products.
View detail
The construction is neither good nor bad, but not overpriced.
The difficulty level of installation is fair, the quality is neither good nor bad, and the price is a little high for the content.
The first step is to remove the OEMFender, but the Instruction Manual is wrong from the very first step.
It says two Bolt, but I have to remove four… I can tell when I see it, as you can see in the picture.
Assembly after removal is as simple as looking at the Parts.
I would have liked the shape and overhang of the License Plate Light to be a little more manageable.
Incidentally, the compatibility with KIJIMA's LED Blinker is subtle.
As you can see in PlateBase, the Small Type-ized Blinker seems to be quite hidden.
It may be necessary to shift the Number down or overhang the Blinker at the time of inspection.
View detail
Exclusive Design.
The gap between the right side and the body is the same as the right side. View detail
It was defective, but Daytona took care of it right away!
The first one I received was defective. (The backrest part's screw bracket is not attachable because the front and back are reversed.) However, when I contacted DAYTONA directly, they were able to respond immediately.
Without this backrest, the RearSeat's handholds would stretch immediately.
View detail
Fits: KAWASAKI ELIMINATOR, KAWASAKI ELIMINATOR SE
It was difficult.
As per other impresarios, it was difficult to stick it on Beauty.
Quantity:The 1pc. eye was in a cruel state and immediately popped.
The second one did not pull the air bubbles out well, but if I continue to re-stick it, Quantity:I gave up because it was in the same condition as the 1pc. eye.
It is functional and will stay that way.
View detail
Fits: KAWASAKI ELIMINATOR, KAWASAKI ELIMINATOR SE
It was difficult.
I had seen other people's impressions and thought it would be difficult, but I still failed.
Quantity:The first pc. fails miserably; the second one is a disappointing failure.
I am using it as it is, but I think it is better than nothing.
View detail
It's Exactly because it's dedicated.
It's a little disappointing to see it from the back because it's a little far away from the car body. View detail
Fits: HONDA Rebel1100, HONDA Rebel500, HONDA Rebel250
It's tough to go it alone.
If two people do it together, there is plenty of room, but alone it is quite scary.
If you have a Rear Carrier with Grab Bar, you may be able to do it by yourself, but it is very difficult because the REBEL is low and there is no part to grab on the Rear side.
I did it with two people at first to make sure I could do it, and then I tried it alone, but I almost beat him.
I think it would be wrong to object to the fact that it cannot be done by one person, since the Manufacturer recommends a two-person operation in the first place.
Motorcycle maintenance is basically a one-person job, so I felt like Minus in that I had to get help every time!
View detail
Fits: HONDA CB1300SUPER BOLD'OR, HONDA CB1300SUPER BOLD'OR SP, HONDA Rebel1100, HONDA Rebel1100 DCT
Mirror Fill-in Bolt
Mirror holes are not used on the clutch holder side, so we filled them here.
The black color is similar to that of the Holder, and I was able to install it without any discomfort.
View detail
Compact
Purchased because my previous New Ing USB power supply was disconnected.
Cover of the terminal is Material:I wonder how waterproof it is because it is plastic, but it looks better than Rubber cap.
The power supply is a bit large, so the installation location is a bit of a consideration...
With CROSS CUB, there is room in the body, so mounting is not so much of a problem.
The cord has a Connector, and if you place the Connector on the Battery side, you can connect DAYTONA's corresponding Charger, but it must be connected directly to the Battery.
View detail
Fits: SUZUKI COBRA, SUZUKI GF250, SUZUKI GSR250, SUZUKI GSR250F, SUZUKI GSX250FX, SUZUKI GSX250R, SUZUKI GSX250S Katana, SUZUKI GSX250R, SUZUKI GSX-R250R, SUZUKI NZ250, SUZUKI NZ250S, SUZUKI ST250, SUZUKI WOLF250, SUZUKI WOLF200, SUZUKI GN125E, SUZUKI WOLF125, SUZUKI Street Magic 110, SUZUKI Street Magic 110II, SUZUKI RM80, SUZUKI RM80V
Maybe LL would be better for Z900RS people?
L makes it seem a little small.
If you make it LL, it's just right.
View detail
Fits: YAMAHA , YAMAHA MT-25, YAMAHA FZ8, YAMAHA FZ1, YAMAHA MT-03
For MT-09 2021 and up
I was using a YAMAHA For M6, the less heavy one, and replaced it with this one.
The high-sider Mirror is EXACTLY hooked and the Handlebar vibration is pleasantly reduced.
It is not listed as compatible, but it will fit into the MT-09 from 2021 onwards with Exactly.
View detail
Fits: HONDA LEAD 50, HONDA MAGNA(V-TWIN MAGNA), HONDA MAGNA(V-TWIN MAGNA), HONDA MAGNA(V-TWIN MAGNA), HONDA LEAD 50, HONDA LEAD 50, HONDA NS50F, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgmanLIMITED, SUZUKI SKYWAVE400 burgman Type S
Purchased wrong size
I bought the wrong size. I'm thinking of buying it again. View detail
not quite
I think the boiler lining keeps the garment warm, but I am not sure.
The windproof fabric is not Stretchable. They are not tight-fitting tights, so they do not feel tight when worn, but I had a very difficult time when men added the Small version. This may not be a problem for those who do not need a front opening, but for me it is a fatal problem.
I think it was a bit iffy, like half windproof or not Stretch.
View detail
Fits: HONDA CB1300SF, Others Only available for vehicles with Quantity:2pc under frame.
UnderFrame Stand
To OH the steering stem of RZ, we fixed it with this product and worked on it.
It would be nice if the height could be raised a little more.
View detail
Fits: YAMAHA YZF-R3, YAMAHA YZF-R25
Not an exact match.
The texture is good
I think the adhesion is also firm.
View detail
I prefer a little more Up.
I wanted a little more angle on the Up. It would be better if the angle could be adjusted. So I am not satisfied with the angle of this Number.
Installation is not difficult, although a little cumbersome.
I wish it were a little cheaper.
View detail
M Size is a large size equivalent to L Size.
[How is it used?
I used to use Komine RACING Gloves, but I started using a motorcycle to commute to work and wanted a pair of gloves that I could put on and take off quickly and easily. However, they were unexpectedly large and it was more convenient to be able to operate a smartphone, so I ended up buying DAYTONA's Cow leather Protector Gloves in S Size again.
Was the one you received as per Image?
The Brown shade, which is not too bright, was just right. The country of manufacture was Pakis Tan.
[How did you feel about the Fit?
I have used gloves of various manufacturers, and the M size was just right for me, but in the case of DAYTONA's gloves, the M size was as large as the L size, and I could not use them at all. The leather is very soft, but it was hard to feel as it was when I bought it, probably due to the lack of oil, so I applied Cream for Leather all over it and it became very soft after about a week. Only the Magic tape on the wrist was just the right length.
How was your experience with it?
The size is too large to be useful. I think the leather texture is good for the price.
[Was there anything that disappointed you?
The Size notation is detaLame.
How did it compare to other products?
It is a large size, equivalent to the L size of other manufacturers.
Other items that would be helpful
Opinion or request to Manufacturer:It is a pity because this is a very good product if only the Size description was appropriate.
View detail