Reviews
Oilfor Replacement
Purchased for engine oil change.
Memory is 200 kyzami, container and sprinkling can section are divided,
The mouth is also small, making it easy to replace.
I recommend it because of its low price
View detail
It is used for dilution of LLC.
[How is it used?
It is used to dilute and pour LLC.
However, it was a little too Large.
Was the one you received as per Image?
It was just like the Image.
I have purchased different capacities of this before.
How was your experience with it?
It does its job of pouring the liquid (LLC) into the Radiator.
There is no particular damage.
[Points to note]
I like the way the hose bends, but it leaves liquid on the bellows part.
Also, there is a gap in the joint between the lid and the hose, so if you store it outside, insects will get in before you know it.
View detail
Lid is Large
There are various types of oil jugs, but I change the oil myself once or twice a year, so without a lid, I end up with dust and garbage all over the place.
So I purchased the lid because I felt it was absolutely necessary to have one.
However, the overall construction is still price-approved, so I am not sure if I would recommend it.
You might as well pay twice as much and buy a better jug. (The one that doesn't have a screw-in Type lid)
View detail
It's quite easy to use, but …
Purchased for Oilfor Replacement.
On the plus side, it is inexpensive and easy to use.
The bad points are that the spout is a little thicker and the volume Memory is rough.
I'm wondering if there is anything more that can be done about the bad points in particular…
It is not an expensive product and I will buy other products to see how they compare.
View detail
It's a lid, so Garbage won't fit in it.
DIY oil replacement is something that is only used a few times a year.
I didn't like that the jug I used to use had to be cleaned first before I could use it again if I didn't take measures to prevent garbage contamination.
This jug has a lid, so I don't think I need to be that nervous about it, but I won't know the results until I've used it a few times.
In the picture of the product description, the cap of the spout is Red, but the one I received was White.
View detail
Used for the first Oil change in my life
I'm an old man who has been riding for more than 20 years, but I haven't changed oil by myself for a long time, but this time I tried to do it. I bought a Oil Jug for this purpose.
I researched the SV650X and found that it needs 2.75L when replacing the Oil filter, so I researched the jug to fit it.
I bought the 2-liter one because I thought I could split it into two portions because it was too large to keep.
When you open the lid to put in the oil, there is a net to prevent foreign substances from getting in, but it is not good.
When I poured Oil, it didn't go through very well and I spilled it on Sheng Large.
I ended up taking it off and putting Oil in.
View detail
Buy at Oilfor Replacement in MONKEY
Because the amount of oil use is 900ml, I was looking for the one of the small size for 1? When storing, the tip of the hose and the spout also have a gap, and the place where the contamination of garbage etc. can be prevented is good, but because Oil does not fall from the Filter of the spout easily and the spout is slanted, Oil flows to the hose when measuring 900ml, and I felt that it was unexpectedly troublesome. I felt it.
If it's 900ml, I think it's easier to remove 100ml from the can and use Bellows to clean it.
View detail
ดีมากเลยครับงานดีกว่าที่คิด ถ้าเป็นฝาแดงเหมือนในรูปจะดีกว่านี้ View detail
Oil is vital for both cars and motorcycles
This is the main oil replacement for cars now, Busa, cbr1000rr, TENERE700, cb650r also use this 2liter, 200cc, 1liter thing and measure the amount well. We use YAMALUBE synthetic 10W40 for motorcycle and Shell for car, so we wash the car oil and motorcycle oil after use to avoid mixing them. View detail
Compact size and easy to use.
It's easy to read the scale and it's convenient to check the amount of oil in the jug when you transfer from the oil can to the jug. View detail
Cheap and effective.
It has a lid to prevent Garbage from getting into the jug and it is convenient for storing engine oil. View detail
Of all the Oil Jugs I've ever owned.
This is the best Oil Jug I've ever had.
The spout is small, just for Motorcycle.
The one at Homsens has a thicker spout and a shorter bellows, probably because it's intended for automobiles.
This is essential for motorcycles that have small oil inlets and are located in intricate areas.
View detail
Convenient and easy to maintain. (* 'Ω `*)
I bought two of these for the maintenance of my CRF150R, one for engine oil and one for gear oil.
I didn't want to have to go through the trouble of checking the level gauge many times when I put the oil in the oil can, so I measured it out and put in about 80% of the specified amount of oil, and then checked it twice to make sure that the oil was injected properly.
Because it is with a lid, it is glad that dust and Garbage do not enter when storing.
I have used it once and kept it by just lightly throwing out the oil inside, but it does not show any deterioration, including the bellows part. I have been using it for about two years in this storage method.
The price is a bit high and the spout doesn't fit in the spout of my motorcycle, so it would be easier to fill it if it was 5mm thinner.
View detail
It wasn't as good as I thought it would be.
I don't want my oil jug to get dirty, so I wanted to find a jug that could be used and stored nicely. I don't want to have to worry about it getting dirty, so I wanted to find a jug that I could use and store nicely. Purchase.
It has a lid, so I wonder if it will prevent dust from getting in during storage. I thought it was a good idea, but it was no good because it was pretty chancy.
I bought a KITACO Oil Jug after this, but this one is solid and has been used for a year. It's in there and it's working beautifully.
View detail
The lids come in handy.
I bought a jug to replace the Oil at home.
I bought one with a lid to prevent dust from getting inside as we store them in a storage room for a long time.
I think that the use is not so different from other jug. I have a 750cc car that is not too small and changes almost 3.5 liters, and I was able to replenish it twice. It was.
The oil spout is a bit narrow, but it was perfect for oil filler. But it takes a long time to get into the small and small size of oil filler when the clay is high.
View detail
How do I clean it?
All of these things may be similar The spout of the Oil is Wide mouth and absolutely no spills There is a plastic mesh on the inside to prevent Garbage from getting in There is also a screw cap on the pour side, so you can leave your oil in and pour it out It is suitable for use as an add-on to a product
As for the feeling of use, it's not too much or too little However, I think it is the fate of this kind of jug, but I have to say that it is not a good idea to remove the oil from the container after use I have a problem with this Especially the Oil that got into the bellows is hard to find in KitchenPaperetc I can't wipe it off First of all, I used Parts cleaner in Jerzya to remove the oil When you leave it with oil on, you can use it immediately It's going to be gone
View detail
large is more convenient for jug
It's a jug for oil, but it's a mixed gasoline for off-road motorcycle as a jug for putting
The drawback is that it is difficult to remove the lid, but it is easy to pour a certain amount of size, easy to pour, and proper The scale of the package is marked on the front, so it is easy to determine how much is in the package I think it's a controlled product
View detail
oil change
I bought this to change the oil myself It's comfortable. It's a good product. The oil is supplied by the manufacturer of the bike. When the oil filter is exchanged on the manual, the amount of oil is determined when not exchanging oil. Therefore, accurate measurement is required. It's a nice product. translated by Google Translator View detail
Easy to use
I've tried using Kosciami, but it's very slow to drop (lol) If you use Oil indoors instead of outside, you don't need it Other than that, Large wood and Nozzle thickness is moderate and easy to use View detail
It has a memory with 200 increments
I bought it to replace the Engine and Defferential oil
Memory is easy to adjust because it is included in 200 increments
It doesn't have a lid, but you can clean it with a parts cleaner when you use it
I recommend it because of its low price
Since the mouth is small, the Coolant liquid can be refilled or replaced
View detail