Reviews
Not Standard Size
25.2mm, so it will be sandwiched between the rubber plates.
However, Rubber sticks out, does not pinch properly, etc. Stress builds up subtly.
In the end, I managed to attach it, but I was not satisfied with the wobble, the subtle texture, and the fact that it was rather large for a skimmer Switch.
I think it would be better to use a 22mm size made by NAKA0 with waterproof and wiring processing...
Well, it's too much trouble to replace it, so I'll use it until it breaks.
View detail
I can't stand the extreme cold.
Used for CUB.
If the power supply has already been removed, installation is easy.
I actually installed it and drove in an environment of less than 10 degrees Celsius.
Although it gets hotter than expected, it can be drowned out by the running wind.
If you are wearing thick winter Gloves, you did not notice much effect.
Thinner Gloves will provide warmth, but the Heater is only in the fingertip area.
It may not hit the ground and cannot withstand the cold in a real winter environment.
Use only in the spring and fall, or use with a Handlebar Cover to prevent cooling from the driving wind.
I think we need to devise a way to do this, such as using a combination of the two.
In addition, the strings for attachment are prone to unraveling, which also requires some countermeasures.
The Handlebar area became a bit cumbersome with the Cable, so we ended up removing it and putting it in storage.
View detail
Fits: HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA GORILLA, HONDA GORILLA
It broke again this time.
Headlight Dimmer Switch, HI and LO Switching Switch is broken
This is the second one I've had already, the first one broke inside my Switch and the second one started the other day.
I can't switch between the two anymore, I hope this Dimmer Switch does something about it because the others are good.
View detail
I broke it
I tried to lightly scrape off the Rib of the Throttle sleeve before installing it, but
It was stuck in the middle and could not be inserted
I couldn't get it off in any way because I had to glue it on …
I feel like I just threw away my Gold …
Make sure you can insert it comfortably before you install it!
I have purchased and installed the Grip heater many times, but this one has a Grip inside
It's made of resin, so there's no play and you need to be careful
View detail
Damaged during installation
I plugged it into the Throttle cone and gave it a good squeeze and it cracked with a dry sound
The Throttle Sutra described in the Manual should have been fine, but alas!
We tried to contact the manufacturer, but it was difficult to qualify it as an early failure Spare parts are still difficult to buy, he said
I thought it would be better to shave it off before you install it
Anyway, it's a shame, it's not cheap, so I won't buy it again …
View detail
Without waterproofing, it gets ruined quickly …
Lack of waterproofing, so it's not suitable for motorcycles, although it does run outdoors It is (It's for Motorcycles …)
The contacts rust out immediately and you have to press the Button It's a shame because the price is good and worth it
If you ride in the rain or wash your car with water, we cannot recommend it
View detail
Fits: HONDA CB650R, HONDA NC750X, HONDA SUPER CUB110, Others , HONDA PCX125
I did not want to cool my hands..
Purchase if it comes to wind blows even by a little in winter commutation of 7 kilometers each way.
It's neither good nor bad.
The shape was the most careful of the hands, but Le Pera - - -
I tried rubbing it in Garage and it broke..
Please be careful about handling.
View detail
"This product is used simultaneously with handle axel wire exchange. Since the general-purpose switch was attached in the middle, it was good to be made to headlight ON/OFF, but it has a difficulty at the most frequently-used cell switch. Although the inn
"This product is used simultaneously with handle axel wire exchange. Since the general-purpose switch was attached in the middle, it was good to be made to headlight ON/OFF, but it has a difficulty at the most frequently-used cell switch. Although the inner configuration is constituted of a spring etc. and it is simple, while using, engagement of components worsens, and a hang is needed for an engine start, or it wakes up loose connection. (a button does not return exactly or a headlight does not turn on.) Therefore, I take into pieces by myself, solder is attached, and contact is maintained somehow. Since the position here was the place where not only start up but various electric systems are involved, I wanted to make it more firm structure. (I noticed genuine greatness.) It is better to cope with some anti-slip, since it will rotate simply if the back pushes a switch slightly strong since it is fixed with a thin rubber. (I put in out of the knee grip rubber and being solved to some extent)" View detail
It purchased as a switch of electronic autoparts. Since my motorcycle had space exactly good for a right-hand side housing, the handle clamp type found this product in search of that which does not lift a hand from a handle using the space of that hou
It purchased as a switch of electronic autoparts.
Since my motorcycle had space exactly good for a right-hand side housing, the handle clamp type found this product in search of that which does not lift a hand from a handle using the space of that housing but whose button grabbing is possible, without using, if it can do.
The main part was well settled in space up to its expectations, and it is satisfied with the type thinly stuck with double-stick tape of the main part.
Two stars are used by saying that it is a little expensive too.
Although the thing which is used for others in a similar manner at a low price from this product was looked for, it is the touch referred to as a thing ideal as a result having only this product, and having purchased it reluctantly.
Although it is a switch with wiring, I think that a little less than 3000 yen is high.
Incidentally about waterproofness, it is unknown.
Nothing was written on the catalogue.
In the seen touch, it is not flooded from the place out of which wiring has come.
Although it may run on a rainy day or may have parked, it can be used satisfactorily the place which is Kon.
View detail