Reviews
MC286V MONKEY/GORILLA Main Harness
OEM Product was discontinued, MC21 and others were sold, but MC28 was sold for MC28, so it was purchased immediately.
It is a bit expensive, but OEM Product is discontinued, used ones are also quite expensive, and there is no worry about contact failure; new ones are safer.
Some OEM Product and Connector types seem to be different, but it does not matter as long as they can be connected.
For some reason, the price sold by the producer was higher than the price of the product, and the purchase here was cheaper, free shipping, and the Point was also reduced.
View detail
Fits: その他 , HONDA NSR250R, HONDA NSR250R
For Waterproof Protection
Honda Series WaterproofBullet TerminalCover10 PairsQuantity:It was a set, so I bought it to protect the BlinkerWiring section, etc., and to use it for waterproofing.
The price is not that bad, there are a few of them, and the Rubber shape is not bad.
View detail
Fits: HONDA NSR250R, HONDA NSR250R, HONDA NSR250R
Adjustment
I bought it because I thought it would be useful for RCValve's adjustment.
Although it is used infrequently, it is not that expensive, so it is a useful product to have.
View detail
Expected Effectiveness
I was worried about other products to replace it with WidePulley.
Safety device on conventional WidePulley (OvertorqueReleaseSystem) I thought that this product would be good for preventing breakage and trouble because it was a reliable WidePulley that had a I thought so and purchased this one.
We are looking forward to seeing the effect after the replacement for a while.
It is a little more expensive than others, so if this doesn't work, it will be a disappointing product.
HI ni Susumu-kun. It would have been helpful if it also came with a "+", but I thought it would be more convenient to have it for adjustment, so I purchased it separately.
View detail
I put it in for water temperature in the summer:....
The low temp Thermostat has arrived and will be installed immediately.
I used Type 2 this time, considering the winter season.
The work time is about 30 to 40 minutes even if you take your time.
My vehicle is an MC18, but I think the work time will probably be the same for any model.
I have done a test drive immediately after installation.
The temperature on the day of the run is approximately 30 degrees Celsius (in the city).
I have driven about 100 km on city + mountain roads, and I think the temperature rise has slowed down a bit.
While driving in Nagoya city, stop&go is repeated so that once the water temperature rises, of course, it is almost the same as in NORMAL.
The only thing I would say is that it is a little better because sometimes it is below 65 degrees.
On the mountain roads, as long as the pace was reasonable, I was calm at 60-65 degrees.
As a result, I honestly thought it was fine for me to have it or not.
Maybe the 18 Radiator is so crappy that it's no good! I wonder if the Radiator after 21 will be able to experience the effect?
Probably expensive, but I feel that for 18, Radiator should be changed as well.
View detail