【ACERBIS】Skid Plate Review
Works like a skid plate should
Installation will require only 5mm bolt. Color match is wonderful for bike. Immediately took this to a local trail to test it out and managed to slam it on some rocks. Held up great, took a bit of damage but that's what it's for! Its tough but it's still plastic so I'm sure it has its limits.something to protect the finish on the frame and keep the mud off the motor.Little to no gaps, excellent coverage of major components.You will need to remove this skid plate when you change your oil.But if you are a little lazy about your oil changes, this may not be for you.This is the perfect solution and was reasonably priced.
Responses
Other reviews
Wide range of Guard
It is more solidly built than I had expected, and my imagination that it was just a plastic board was betrayed in a good way.
Installation is easy, as only four screws are needed for installation.
I think it is better to install it after Grease up well because the screw holes are likely to be rusted by water in the location.
Since it covers the underside of the Crankcase, I think the construction is quite promising in terms of Engine protection.
View detail
Lightweight skid plate!
This is a light Material:This is a Plastic Skid plate.
But it seems to be quite strong.
I chose ACERBIS Black because I don't intend to use it for hard use like TRIAL or attacking rocky terrain.
The body of the car is Color:Gray and Orange, so Black, the same color as the Frame, blends in well.
The installation went on easily without any positional issues. First, I applied grease to the screws and tightened them once only with screws.
When replacing the Oil, it is necessary to remove it, but it seems to take about 5 minutes.
2023 CRF250L Installed on 8bk-md47.
View detail
Hole position is not good
I put it on my 8BK-MD47, and the holes on the Left side are not aligned when viewed from the Front, so I had to force the Left side up, then the Right side up, then the Bolt in the rear to get the Bolt to fit. If there was a penetrating hole at the oil drain bolt position, it would have been better to save the removal when changing the oil. View detail
Does not break the Style of the car body
【good point】
Light
Looks sturdy.
Easy to install.
It is hard to be confused with others.
[Bad point]
The mounting holes were gapped and needed to be machined.
There is no hole for drain bolt.
Fallen leaves accumulate between the body of the vehicle and the Plate.
It could be done more cheaply.
View detail
The color matches well with the CRF300L and is pretty, which is nice, but the bolt location wasn't right so it was difficult to install.
The color matches well with the CRF300L and is pretty, which is nice, but the bolt location wasn't right so it was difficult to install.
I did some processing on the bolt location and it went in well.
I intend to purchase it again next time and am satisfied with the product.
ㅏㅁㄴㄹThis ㅓㅁㅇㄻNoreinㅁㅇI don’t know what to expect, but I don’t know where to come. ---------------------------------- The color fits well with the CRF300L, but it was good, but the bolt was not right, so it was difficult to install it. I put a little processing on the bolt position and put it in Next time, I am willing to buy again, and it is a satisfying product ㅏ ㅁㄴ ㄹ ㅓ ㅁ ㄹ ㄹ ㄻ ㄻ ㅁ Powered by Google Translator
View detail