【amon】Shrink Tube Review
Where Solder is connected, etc.
It can be used for branching connection with a solder, protection of Cable, etc.
It would be better to shrink them with a heat gun, but they are shrinked by lightly frying them with a lighter.
Be careful not to put the flame too close to it or it will melt.
Responses
Other reviews
Cospa best
After wearing Wiring as a solder, the process is easy and Beauty. View detail
Convenient
I used it in the Wiring retainer to avoid Short when processing Wiring.
Installation is easy as it shrinks when heated in the Dryer.
It will look good and finish as if a PRO had done the work.
View detail
Easy to use
I bought this to clean up the Solder section of Wiring.
It is easy because it shrinks when heated with a heat gun.
After that, it hardens slightly and protects WellWiring.
The contents are just right, and at this quantity, I won't have to buy any more for a while.
It is not expensive, so recommendation is to buy several kinds by thickness.
View detail
It is good
I bought this to clean up the Solder section of Wiring.
It is easy because it shrinks when heated with a heat gun.
After that, it hardens slightly and protects WellWiring.
The contents are just right, and at this quantity, I won't have to buy any more for a while.
It is not expensive, so recommendation is to buy several kinds by thickness.
View detail
Easy to use
I bought this to clean up the Solder section of Wiring.
It is easy because it shrinks when heated with a heat gun.
After that, it hardens slightly and protects WellWiring.
The contents are just right, and at this quantity, I won't have to buy any more for a while.
It is not expensive, so recommendation is to buy several kinds by thickness.
View detail