【DAYTONA】Fuel Filter (Non-Disassembly Type) Review
It is a must for older Motorcycles.
For older Motorcycles, it is a must.
The easy installation and low price are highly appreciated.
Responses
Other reviews
It is a must for older Motorcycles.
The device was installed on a KDX250SR.
Since it is an old Motorcycle, it is ideal for Tank's Rust defense.
View detail
periodic replacement
I installed it to prevent foreign matter from entering the tank, and it is about time for regular replacement. The price is not that much, I can see how dirty it is, and it is easy to replace, so I think it is easy to use. View detail
Essential equipment for older vehicles
After riding for a long time, the cold temperature difference causes condensation inside the Tank, resulting in water droplets.
Water will collect on the bottom of the Tank and may rust.
Rust debris can enter the carburetor, causing overflow and clogging of the jets.
This is where this product is useful.
If there is some rust, the filter can trap it, and since it is visible through the filter, it is possible to notice rust as soon as possible and take measures such as rust removal.
This product is compatible with φ6 and 8 and can be used from Mini bike to Large type.
View detail
Small Type
Small type as a fuel fliter, and since it is a paper base, it is the one that you should be most careful about in terms of narrowing down the flow rate.
However, because it is a Small Type, there are many cases that are convenient for placement.
View detail
To prevent foreign objects from entering
[How is it used?
I used it on my TZr250R.
We do have rust removal on the Fuel Tank and of course the Cook has a Filter, but we use it as an insurance policy to prevent as much rust and Garbage from flowing away.
Was the one you received as per Image?
If you have a vehicle with limited space, it's a good idea to check the installation position beforehand.
How was your experience with it?
Hose inner diameter is φ8mm, so I cut off the tip part with Cutter and then installed it.
I've only run the engine a little bit since installation, but so far the flow rate seems fine.
I can't confirm the visible foreign body etc. at the moment, but it seems to catch it well.
[Points to note]
If you just look at the Body, you'll want to put it on backwards, but the orientation is as shown in the picture.
I don't think it's a problem because it's in the description, but you need to check the mounting direction.
How did it compare to other products?
This is my first time installing a Filter, so I don't know about other products, but it's good that it can be used for both φ6 and φ8m, so it can be used in any car model.
【Review】
You don't have to measure every Hose inner diameter, but you can be sure to buy this product.
It seems that only Gasoline flow rate may be a problem, so you need to be careful there.
View detail