【K&P Engineering】[Repair / Optional Parts] X-Ring Type1 (O-Ring) Review

Now you can rest assured.

The original packing ran out after the fifth oil change, so I replaced it with a spare packing.
Even if there is something wrong with the packing the next time the oil is replaced due to poor installation on my part, I can replace the oil without worrying because I have another spare. View detail

K&P OEMRepair Parts.

I have not used it yet, but when I was looking for it, I found it in this shop.:5pcs. ordered.
I thought it was a Universal Product, but it was an OEM Product. I thought it might be a Universal Product, but it was an OEM Product.
Also, since there was a PayPaySilver bank for transferring money, there were no transfer fees.
I bought in bulk, so I think it will last for a while, but I would use it again.
Thank you very much View detail

Dedicated O-ring for Cartridge

Two K&P S1s and one S9 are attached to each body.

The O-rings here are not so much to be replaced as they are to be
The O-ring that was attached from the beginning during the recent Filter cleaning is a little
It was almost torn, so it was included as a spare when I purchased the Filter.
I tried to replace it with an O-ring, but it must have deteriorated over time.
It was a little swollen and difficult to get into the Filter groove.
(I was able to get away with it by shrinking it down to an even etc. in the mizo...)

It's probably about four years old, so deterioration is inevitable.
As I was saying, the O-ring that I had saved to use when the time came to use it came.
If you can't use it, you can't talk about it, so I'm going to use a couple of them as Stock.
I bought it

This O-ring is a special product, so it would be better to have a spare in advance.
I think I will replace them regularly from now on regardless of damage. View detail