【A-TECH】Under cowl inner tray Review
Lots of interference.
Purchased to prevent stains rather than to receive Oil.
Material:It is made of FRP and weighs 580g.
As is, there are no nests or hickeys, but there are many Small scratches and scuffs, so it is painted.
Lightly polished with #1000, sprayed with a buffing compound, and painted with 2-component urethane.
Cut because it interferes with Bracket and Hose near Side Stand, although it is not mentioned in other reviews.
Cut because it interferes with the IndonesiaFull Exhaust System that is being installed.
It was difficult because there were many parts to cut and a lot of cutting.
Prepare cutting and cutting tools for those who purchase them, as they are difficult to use with manual tools.
Responses
Other reviews
It's hard to install
Cowl was burnt due to interference with the lower part of the vehicle body.
Since it is installed inside the cowl, there is a limit to how much modification can be done, so we gave up on using it.
View detail
Used as Oil receiver for Circuit run
I installed it on my Ninja 250SL that I ride for Circuit Racing.
Since it is a dedicated product, it can be basically simply installed, but there may be some interference depending on the exhaust system being used.
I had OEM Exhaust System and YOSHIMURA Slip-on Silencer, but there was a little bit of shaving part.
View detail
Concerned about strength of some parts
FRP was selected because the parts are not so heavy even in resin, and weighed about 600g.
I thought it would not need much strength, but when I held it horizontally by the edge, it made a squeaking sound, so I think it would be better to use Carbon if you are concerned about it.
The hole where the cowl is tightened with the frame is slightly out of alignment and the shape does not follow the frame.
I used Chinese Link pipe and needed to cut the back end, so I cut it with Grinder for Hobby.
Sandwiching type on the inside so there is no risk of scratching the OEMCowl, and it looks like a racing machine, which is cool.
View detail
No dimensions.
Size does not match.
Instead of buying this, you should buy the Magical RacingUnder Cowl Tray.
View detail
Processing essential
Installed on zx10rr-2019 MODEL
It was unprocessed and could not be installed.
The position of the hole on the Left Side of the Gap interferes with the protrusion of the OEM Cowl and cannot be tightened by Bolt.
Improvements?
The Left Side (STAND side) hole must be extended.
Everything else was fine.
As a side note, I liked it shorter, so I cut about 5 cm from the back to install it.
View detail