【DAYTONA】Lightweight License Plate Holder Review
man who will not bend
I once had a crack on my moped license plate, and after consulting with a motorcycle shop, I was told that I could use a washer between the screw and the plate holder to prevent vibration. Since then, I have been buying and using PlateHolder for all types of vehicles.
DAYTONA's License Plate Holder comes in a variety of colors, so it was hard to decide. At first, I thought I would choose Gold, which is not seen very often. However, I thought that the yellow color Number would look too large, so I decided to go with black this time.
It is easy to install and the material is aluminum plate. The spacer is also more solid than shown in the photo. The PlateHolder gives the PlateHolder a high quality feel and a top ranking. It also protects the thin and bendable moped license plate.
Moped License Plates have different shapes depending on the municipality. The recently popular local moped numbers are often of a unique shape. Plate holders with raised edges cannot be installed. It is advisable to check the shape of the number before purchasing.
Basically, when you buy a new car, you also get a new License Plate. New plates look good on new cars, so I buy a new Plate Holder every time I buy a new car. I am planning to change the color of the Number to Pink in the near future, so I will buy a new one in a new color. It comes with Washer, but the price is not too expensive, so it is very helpful.
Responses
Other reviews
It was not for 125CC!
I thought I bought it for 125CC, but the product is for Horizontal Type, so the upper Quantity on the License Plate is not available.:Pair (for Left and Right) has overflowed.
The reason is that I did not carefully check the shape of Engine Displacement Volume and License Plate.
It is a waste to replace it with another product so we use it with the overhang.
Parenthesis bad (crying)
View detail
It's normal
Can be installed normally.
However, I think it would be troublesome to clean it if it gets dirty.
View detail
Very good
It also goes very well with the Fender Eliminator Kit. View detail
For License Plate protection and Dress-up
I installed it on my CT125CT110 HUNTER CUB.
It's nice because you don't have to worry about the License Plate bending and it looks tighter.
I don't think it will affect it that much, but it's nice to see that it's been butchered and lightened.
I didn't use it because the plate Washer that came with it was Large fine-grained and it was subject to CALI Seal and became Wrinkle.
If you are concerned about this, you should check it carefully and install it or prepare the CALI Plate etc. separately.
View detail