- Home
- Product reviews
- Tools
- Other Tools
- Nicely made and very useful... (DAYTONA: Magnet Bench Vice Pad)
【DAYTONA】Magnet Bench Vice Pad Review
Nicely made and very useful
Pretty good at holding motorcycle parts or softer metal you don't wish to mar with the vice teeth. I purchased 2 different jaw pads. Plastic and metal. All were very similar. They give multiple ways to hold part secure with damage. Good quality and durable. Retention magnets are weak though, slight bump and they fall off the jaws. Holding round rods at an angle or parallel to the teeth, not so much. They will warp if given too much torque.
ทำมาอย่างสวยงามและมีประโยชน์มาก
ค่อนข้างดีในการยึดชิ้นส่วนรถจักรยานยนต์หรือโลหะที่นิ่มกว่าที่คุณไม่ต้องการให้มีฟันรอง ฉันซื้อแผ่นกรามที่แตกต่างกัน 2 แผ่น พลาสติกและโลหะ ทั้งหมดมีความคล้ายคลึงกันมาก มีหลายวิธีในการยึดชิ้นส่วนให้ปลอดภัยเมื่อเกิดความเสียหาย มีคุณภาพดีและทนทาน แม่เหล็กยึดยังอ่อนแอ มีชนเล็กน้อยและหลุดออกจากขากรรไกร ถือแท่งกลมเป็นมุมหรือขนานกับฟันไม่มากนัก พวกมันจะบิดเบี้ยวหากได้รับแรงบิดมากเกินไป
Show originResponses
Other reviews
This is very useful when you don't want to scratch it.
I bought it hoping I could use it to hold round or unstable objects in place.
It is not fixed to Solidly, so it is a little unreliable when you want to cut with a hacksaw. It's just a supplementary tool.
The magnet on the back makes it easy to attach to Vise. I also keep it attached to my iron desk for storage.
View detail
dull
[How is it used?
I use Vise to fix parts that I don't want to scratch or deform.
How was your experience with it? [Points to note]
I can grab it, but the Material is too soft to do any fixing.
If you are pulling with a Gold cutting saw across a Bolt or similar object, it will tilt and the cutting surface will be slanted.
The same is true if you are grinding with File.
You will need to reposition the child several times along the way.
I've been using it for a while now, but I've given up on it because I can't find anything else to replace it.
Because it is resin, you must not do it because it melts by heat when you sand the grasped genus Gold. It will be irretrievable.
How did it compare to other products?
I also have one made by Straight (discontinued) which is made of Aluminum with Rubber board attached, but it's not as good as this one.
[Opinions and requests to Manufacturer
Material should be made of copper, but I don't think it will be expensive.
At least, if it is made from 1000 aluminum plate, it can be gripped Firmly and it is strong against heat.
View detail