【ODI】V2 lock-on grip no waffle Review
Fits: HONDA CR125R, HONDA CR250R, HONDA CRF250R, HONDA CRF250RX, HONDA CRF450R, HONDA CRF450RX, YAMAHA YZ125, YAMAHA YZ125X, YAMAHA YZ250, YAMAHA YZ250X, YAMAHA YZ250F, YAMAHA YZ250F, YAMAHA YZ450F, YAMAHA YZ450F, YAMAHA YZ250FX, YAMAHA YZ450FX, YAMAHA WR250F, YAMAHA WR250F, YAMAHA WR450F, YAMAHA WR450F,
Best of Thin Grip
YZ125X (MY22) The first time I went out to Race, I installed it on a
Before this, ZETA's BaseGripSlim (ZE47-6021) used to use.
situation in which a person's hands are small and their face is partially concealed (esp. from behind the scenes) (Gloves are available in Men'sS Size or LadiesL Size) So, I am constantly looking for a thin Grip.
If you look at MAJOR, I think this ODI no-waffle or ZETA's BaseGrip would be the smallest diameter at 29mm. (Check yourself)
I feel that there is less vibration in my hand compared to my previous ZETA BaseGrip.
It may be a difference in Compound, since ZETA should obviously be thicker in Rubber thickness due to its structure.
Of course, the ease of installation that Lock on grip offers is very good.
The ease of removal is very appreciated when you want to switch between multiple Handlebars for a test run.
Also, in the case of YZ125X, it can be installed with the supplied Cam.
There are two caveats.
One is with the hand guard.
Since this grip has only a closed end, it is necessary to drill a hole in the grip end to attach a closed hand guard.
Unlike ordinary grips, the inside is made of a plastic tube, so it is necessary to use a Footpeg Drill or similar.
The other is with Handlebar.
If the Knurl on the Clutch Side of the Handlebar is Large, it will not fit unless the Knurl is cut away to some extent.
I put it on a Pro taper Konzer and it scraped off quite a bit of Knurl.
I had a ClosedHand guard + Konzer, so it took me about 30 minutes to install it.
I will have to use it more in the future to see how it works, but I feel this is fine unless you are very Muddy.