【KITACO】Bar End Cap Review

The Shock driver in the instruction manual is not required.

About the product
The texture is very good, but it is smaller than expected. Grip and Bar End Cap A gap opens between the (Total weight:170g/OEM equivalent)
Installation
It's in the instruction manual. Shock driver." is not required.
Utilizing BOXWrench to meet Cap bolt (M6×40) standards. +Bit." and expressed in 10 levels of force, it can be loosened with about 30% of the force.Cap bolt has a Screw lock." A small amount of the "P" is applied and can be installed in about 5 minutes.
About the running test
We will re-submit if we feel a change is warranted. View detail

Received and immediately ...

I replaced it! This product is about the same weight as OEM and Balance is also good. I also like Design and I decided to go with Motorcycle's AttachmentCatalogue as well.
Work is to remove the OEM When it is a normal Driver Screw is hard so do not lick your head Impact Driver (Referring to other people's impressions) With BALIBALI cuisine for a moment (^_^) v
Next, apply Screw lock to the Bolt of the new Cap, align the unevenness of the ground contact surface of Cap, and immediately tighten it with Hexagonal Wrench.
I was working while dancing with Shure, but it was completed in about 10 minutes. It will be about five minutes if I do it quietly.
With the last Bolt retightening, there was not a reasonable tool to fix the Cap which would rotate, there was no choice but to tighten it with Wrench while grasping by hand. So, I'm a little worried about whether it will come loose with vibration, but I believe in the power of Screw lock (^. ^;)

And the impression after exchanging ... Stainless Steel glows and becomes one point, a little luxurious feeling comes out around Handlebar and it gets better Parenthesis It is satisfactory (^-^)
However, whether the cutting angle of the ground contact surface of Cap is not horizontal, or whether the core does not come out by grinding the table, or if the cap is rotated after the installation, the head delicately shook the head.. (Bitter) That's disappointing. ('Д `) Also, something like grinding streaks on the machined surface of the surface is a bit .... So ☆ Four.
With tools, it's easy and casual Dress-up so it's Recommendation! View detail

I installed it in Blue color PCX

I bought this item for One point around Handlebar. In order to install it, it is necessary to remove the OEM Bar End, but in ordinary Driver it does not relax at all and we relax the Impact Driver by Barrel at Home center. It became Accent around Handlebar as aimed.
I am completely satisfied with my self. View detail