【DAYTONA】Screen Offset Bracket Review
Easy installation
When removing the OEMScreen, hold the Screen and carefully remove it when removing the last one
When installing the bracket, it is easier to temporarily assemble the Multi Bar, but since the holes for installing the Multi Bar are long holes, it is better to tighten the bracket by hand to some extent to prevent scratches on the bracket.
The bracket is not completely fixed, but slightly loosened for installation.
Use top and middle holes when mounting Shield at 5cmUp
The Bracket can be mounted straight by temporarily fixing the holes on the underside of the Shield.
All that remains is to tighten the Bolt on the OEMScreen. The Bolt on the upper side must be tightened with the nut in place or the paint on the Bracket will be damaged.
Even a 5cm rise in height is enough to provide wind protection.
The Cap Bolt Cover can also be personalized by choosing a color that is sold separately (although it is more expensive...)
Responses
Other reviews
For mounting of Smartphone Mount
I bought this for mounting my phone mount, it is Exclusive Design so it is easy to install and has a high quality feel. I am glad I was able to place the phone at eye level, and it would be even better if the Bracket was lightweight! View detail
The one and only product so far!
Currently, this is the only thing that can combine the function of raising the Screen in addition to the Bracket function.
I think this is a good product for VSTROM250SX.
I'm planning to put a Radar detector or something on the Bracket, but I don't have any problem with the bar thing.
As for the 50mmUp feature, there is no problem, as it is not too different.
The effect is better than no effect at all, even though it is a little bit larger than the original target of the body (up to the shoulder area).
It is a product that is sure to be nested, as options are almost non-existent at the moment!
View detail
Smartphone Mound Bar Purpose
This is comfortable equipment for viewing Smartphone Navigation without lowering the eye level.
The installation required a 6mm Allen Wrench in addition to the on-board tool because the tool was not enclosed.
Just raising the height of the Screen by 50mm is totally windproof.
The ETC Antennas are located behind the Screen, but even if they are raised 50mm, they are protected within the frame, so rainwater will be large and strong.
View detail
Installation Easy
It is easy to install.
However, the phone mount bar vibrates slightly while driving, so the phone must be securely attached.
View detail